Waterco Hydroxzone Ozone Generator Owner's Manual - (Water Balance)
2.3 INSTALL THE SADDLE CLAMPS (BYPASS)
1. Turn pump OFF.
2. Locate section of existing plumbing in which you choose to install the ENTRANCE leg of
the bypass. Location should be in any accessible area after the pump, but before the filter
(Please refer to Figure 1.1).
3. Install Saddle Clamp Top & Bottom, (and adapters if needed), without bushing, (this will be
used as a guide for your installation hole).
4. Drill a 7/8”/22mm hole through one wall of the pipe, using power drill, being careful not to
drill too deep to avoid penetrating the opposite side of the plumbing.
5. Locate section of existing plumbing in which you choose to install the EXIT leg of the
bypass (Please refer to Figure 1.1). Location should be in any accessible area after the filter,
and heater (if equipped).
6. Repeat steps 3 & 4.
7. Remove both Saddle Clamp Assemblies.
8. Using components listed, mount one Saddle Clamp Assembly on Entrance bypass location
with the INLET side of the Venturi Injector mounted in the Saddle Clamp Bushing, (ozone
ports should be facing upward). Tighten both screws. (refer to Figure 2.2)
9. Using components listed, mount the other Saddle Clamp Assembly on Exit bypass location
with the 15mm x 75mm length (½” x 3”) PVC pipe mounted in the Saddle Clamp Bushing.
Tighten both screws. (refer to Figure 2.3)
10. Attach one end of 20mm (¾”) clear hose to Venturi Injector and secure with a metal clamp.
Attach other end of 20mm( ¾”) clear hose to 15mm x 75mm Length (½” x 3”) PVC pipe and
secure with a metal clamp.
11. Mount the Hydroxzone Ozone Generator on a wall or surface at least above maximum
water level to prevent water from contacting the electrical equipment. Unit orientation will
not affect performance.
2.2 RECOMMENDED WATER CHEMISTRY
(WATER BALANCE)
Consult the local pool professional for the correct water balance according to the swimming
pool type.
PARAMETER
SUGESTED VALUE
pH
7.2-7.6
Total Alkalinity
60-200 ppm
Calcium Hardness
100 -500 ppm
Stabiliser (Sunscreen)
60-60 ppm
Phosphates
<0.2 ppm