Waterford Trinity Mk II Installation & Operating Instructions Manual - page 11
10
IMPORTANT: BURN WOOD ONLY. DO NOT BURN
COAL, SYNTHETIC LOGS OR OTHER FUELS.
BURN DIRECTLY ON HEARTH, DO NOT USE A
GRATE OR ELEVATE FIRE.
“NEVER USE GASOLINE”, GASOLINE TYPE
LANTERN FUEL, KEROSENE, CHARCOAL
LIGHTER FLUID OR SIMILAR LIQUID TO START
OR “FRESHEN UP” A FIRE IN THIS HEATER.
KEEP ALL SUCH LIQUIDS WELL AWAY FROM
THE HEATER WHILE IT IS IN USE.
OPERATE STOVE ONLY WITH FUELLING DOOR
AND ASHPIT DOOR CLOSED.
THIS HEATER IS HOT WHILST IN OPERATION.
KEEP CHILDREN, CLOTHING AND FURNITURE
A SAFE DISTANCE AWAY.
VENTILATION & COMBUSTION AIR
REQUIREMENTS
Ventilation and adequate air supply is necessary to
supply combustion air to the appliance. Refer to
your Local Authority for current requirements in your
juristriction.
Outside combustion air may be required if:
1.
The solid-fuel-fired appliance does not draw
steadily, smoke rollout occurs, fuels burns
poorly, or back drafts occur whether or not
there is combustion present.
2.
Existing fuel-fired equipment in the house,
such as fireplaces or other heating appliances,
smell, do not operate properly, suffer smoke
roll-out when opened, or back-draft whether or
not there is combustion present.
3.
Opening a window slightly on a calm
(windless) day alleviates any of the above
symptoms.
4.
The house is equipped with a well-sealed
vapour barrier and tight fitting windows and/or
has any powered devices that exhaust house
air. (e.g extraction hoods and tumble dryers
etc.)
5.
There is excessive condensation on windows
in the winter.
6.
A ventilation system is installed in the house.
If these or other indications suggest that infiltration
air is inadequate, additional combustion air should
be provided from the outdoors. Outside combustion
air can be provided to the appliance by the following
means.
1.
Direct connection: Refer to O.S.A. Hook-up in
this manual.
2.
Indirect method: for an appliance not certified
for direct connection of outside combustion air,
than (12”) 300mm from the appliance, to void
affecting the performance of the appliance.
3.
A mechanical ventilation system: if the
house has a ventilation system (air change
or heat recovery):
a. The ventilation system may be able
to provide sufficient combustion make-up
air for the solid-fuel-fired appliance.
b. The householder should be informed that
the ventilation system might need to be
re-balanced by a ventilation technician
after installation of the appliance.
SPILLAGE TEST
1.
Light/burn appliance under normal condi-
tions in accordance with this installation
manual.
2.
Close all doors and windows.
3.
Operate all appliances requiring a full rate
(eg. extraction hoods, tumble dryers etc).
4.
Check for spillage.
LIGHTING
(a) Replace ashpan (item 37), close ashpit door
(item 13), and make sure the ash dump sliding
door (item 42) is closed by pushing in ash dump
lever (item 54) located at the bottom of the left
side panel when looking from the front of stove.
(b) Open fire door (item 8) and open the primary air
duct (item 55) by pulling the primary air control
lever (item 66) located at the right corner under
the ashlip (item 12) all the way towards the front.
(c) Cover hearth with crumpled pieces of paper. Lay
dry pieces of kindling approximately
1
/
2
” (12mm)
x
1
/
2
” (12mm) x 20” (508mm) long on top of the
paper towards the back of the firebox. Ignite and
close the fire door (item 8). When the kindling
has ignited, open the firedoor (item 8) and add
larger pieces of dry wood. Close the firedoor
(item 8). When a hot bed of coals is established
add the normal fuel of well seasoned split logs
approximately 20” (508mm) long. Once the logs
are well lighted, adjust the primary air control
lever (item 66) to the required output.
Refuelling – Open the firedoor (item 8) and carefully
level the embers and re-load with logs, close the
firedoor.
NEVER STORE FUEL WITHIN SPACE HEATER
INSTALLATION CLEARANCES OR WITHIN THE
SPACE REQUIRED FOR CHARGING AND ASH
REMOVAL.
PRIMARY AIR SETTINGS
MAXIMUM – Pull control lever (item 66) all the way
towards the front.
LOW (MIN) – Push the control lever (item 66) all the