WaterFurnace Premier2 Owner's Manual - Drain Pan

15

Premier2 Owner’s Manual

Water Supply for Well Water Systems

An adequate water supply to the unit is very important. Do not let anyone disrupt the water

supply by rerouting the supply line or tapping into it without first checking with your

WaterFurnace dealer. If the well pumping system requires service or is inoperable, your unit

should be turned off until an adequate water supply is restored.

Water Supply For Closed Loop Systems

No regular maintenance is required. However, if you notice air noise within the piping or

your loop is ever damaged by excavation, contact your WaterFurnace dealer.

Drain Pan

• In the cooling mode, moisture removed from the air forms as condensation on the air

coil and the resulting water runs down to the condensate drain pan. The drain can pick

up lint and dirt, especially with dirty air filters. If overflow occurs, the 

DRAIN

 light will

come on and the system will shut down.

• If the water does not run freely, clean the drain pipe. Pour a capful of bleach in the

drain pan once a year. This helps to prevent algae.

• To gain access to the drain pan for inspection: Turn off all power to unit and auxiliary

heat. Remove the screw located above the top center of the fan compartment door.

Lift the door up and pull out at the bottom. The drain pan is the black plastic or metal

rectangular pan with the drain hole in the middle.

What about regular service?

Your Premier2 system requires no regular maintenance. However, once a year or so, have

the unit inspected by an independent WaterFurnace dealer. They will check the unit’s perfor-

mance and make sure that your Premier2 unit is heating and cooling at its peak performance

level. If your unit is using a well as its water supply, your unit may need periodic cleaning to

remove mineral deposits.

If my unit shuts off, how do I reset it?

To reset the unit, repeatedly push the 

MODE 

button on the thermostat until the display

reads 

OFF

.

• If 

FAN ON

is displayed, it must also be turned off by pushing the 

FAN

button.

• The 

TROUBLE

 signal will continue flashing or remain on for up to 60 seconds after

turning the system and fan off.

• After the 

TROUBLE

 signal goes out, turn the system back on to the desired

MODE

 and re-select 

FAN ON

 if desired.

• Unit operation should resume within five minutes if heating or cooling is required.