WaterLogic WL380 User Manual - page 8
WL380 User Manual
Page 11 ‐ Revision: 6‐9‐2016
OPERATING INSTRUCTIONS
TO DISPENSE PURIFIED COLD WATER:
Select cold dispense icon until it lights and hold until desired amount is
dispensed.
Release to stop dispense.
There will be a 2 second initial delay as Firewall purifies cold water and sanitizes the faucet. Cold will
only dispense if Firewall is active to guarantee safest possible water. Cold icon and Firewall Purification
Light are disabled if Firewall is inactive. One minute continuous dispense limit.
TO DISPENSE PURIFIED AMBIENT (ROOM TEMPERATURE) WATER:
Select ambient dispense icon (lower) until it lights.
Hold until desired amount is dispensed.
Release to stop dispense.
There will be a 2 second initial delay as Firewall purifies ambient water and sanitizes the faucet.
Ambient will only dispense if Firewall is active to guarantee safest possible water. Ambient icon and
Firewall Purification Light are disabled if Firewall is inactive. One minute continuous dispense limit.
WARNING!
HOT WATER can cause severe burns or scalding. Unit produces Hot Water( 189
o
F / 87
o
C).
Keep unauthorized people and children away from the unit to avoid injury and accidental dispensing.
TO DISPENSE HOT OR EXTRA HOT WATER:
Select HOT (middle) and AMBIENT (lower) icons together until both light
Hold until desired amount of hot is dispensed.
Release to stop dispense.
Icons must be held simultaneously for 2 second before hot will dispense.
This delay is a safeguard to prevent accidental dispense or unauthorized use.
NOTE:
Hot water may not be immediately available if unit is in energy saver mode. Select any icon to
“wake up” or reactivate heater and wait a few minutes for hot water to be produced.
EXTRA HOT CYCLE (Raise Hot Tank to Elevated Temperature for Tea and Soup):
Select EXTRA HOT CYCLE icon until it lights and hold for 2 seconds then release.
The icon will flash indicating the extra hot cycle is activated. Icon will continue to
flash while water in hot tank heats to extra hot set point (default 203
o
F = 95
o
C).
Flashing will stop once tank has reached extra hot set temperature (typically a
minute or two). Extra hot water can now be dispensed per instructions above.
NOTE:
Icons will light when depressed to validate selection. A soft touch is all that is required.
A one minute continuous dispense timeout is built in as safeguard. Release and reapply to override.