Waterpik WP-480 Quick Start Manual

 QUICK START GUIDE

1

3

4

Model WP-480

The battery charger is only compatible with a voltage system of 120VAC, 60Hz. 

Do not plug the battery charger into a voltage system that is different.

continued on back

The Water Flosser 

has 3 settings on the 

power switch. 

O (off)

, 

I (low)

, and 

II (high)

. 

Use the 

low (I)

 setting 

for first time use. 

Increase to 

high (II)

pressure over time, if 

you prefer – or as 

instructed by your 

dental professional.

Battery Pack Insertion:

Insert Tip:

Adjusting Pressure:

Charge battery pack for 

24 hours before first use

Slide battery pack 

into handle, lining 

up the arrows and 

rotate clockwise 

until it locks into 

place. The arrow on 

the battery pack will 

line up with the lock 

symbol on the back 

of the Water Flosser. 

Select the appropriate tip and insert 

into the unit. Press firmly until the tip 

clicks into place. Gently pull on tip to 

confirm it is seated 

properly and locked 

in place. 

Plug charger into standard 

electrical outlet 

(1)

. Line up 

arrow on the battery pack 

with arrow on the charger 

labeled “insert” and insert 

battery pack 

(2)

. Rotate 

battery pack until arrow 

lines up with arrow labeled 

“charge” 

(3)

. Green light on 

the charger will illuminate.

For Showerpik

®

 installation instructions, please see instruction book

Caution: Do not press 

tip eject button while 

unit is running.

2

charge

Insert

charge

Insert

1

2

3

NO

Gap

Tip 

Eject 

Button

Insert