Watersnake Slider Pro Owner's Manual - page 7
www.watersnake.com.au
7
ELECTRICAL CONNECTIONS
Before connecting the motor’s
cables to the battery terminals,
ensure all switches are in the
OFF position and stand clear of
the propeller.
Connect the red cable to the
positive (+) terminal and the black
cable to the negative (-) terminal,
making sure the terminals are
clean before doing so. A clean
connection will minimise power
wastage and give you maximum
power from the battery.
Please Note: for best performance
please keep battery terminals and
connections clean.
A Watersnake 50 Amp inline fuse
kit is supplied and attached to
the red power cable to protect
the circuit boards of the motor.
This is a connection that joins the
motor battery cable to the battery
and shuts the motor off if the
connection over heats. As shown
on diagram (1)
We recommend using a deep
cycle marine battery for
optimum performance.
DEEP CYCLE BATTERIES
Deep Cycle batteries are
constructed using thicker battery
plates and a denser active
material to withstand repeated
charge and recharge cycles.
Rather than providing high bursts
of power for short periods of
time they are specially designed
to deliver sustained power with
low current draw over extended
periods of time.
*
50 amp
circuit
breaker
(1)
SLIDER PRO