1. DL manuals
  2. Waterway
  3. Water Filtration Systems
  4. SVL56
  5. Owner's Manual

Waterway SVL56 Owner's Manual

Other manuals for SVL56: Owner's Manual

Summary of SVL56

  • Page 1

    Owner's guide installation instructions g eneral d escription crystal water/aqua clean cartridge filters are high performance swimming pool and spa filters. Manufactured from durable, corrosion-proof thermoplastic.They are designed for continuous or intermittent operation, for installation above or ...

  • Page 2

    1 1. Installation: pump selection and location: to power your filter, select a continuous duty pump designed for swimming pool or spa service. It is important to first determine where your pump and filter will be located. If above the water line, a self-priming pump such as workman, svl56 or the mus...

  • Page 3

    7. All electrical connections should be made in accordance with local codes. 8. Caution: ansi/ nspi-4 article v, standard for in-ground pools, advises that components such as the filtration system, pumps and heater be positioned so as to prevent access by young children. 6. A filter drain plug is fu...

  • Page 4

    12. To clean/replace cartridges: before removing cartridges elements: shut off pump. If filter is located below water level, close valves (or block off suction and discharge lines) to prevent backflow of water from pool. 12. Limpieza/reemplazo de los cartuchos: antes de remover elementos de cartucho...

  • Page 5

    16. Cleaning cartridges: the cartridge filter element can be cleaned by pressure wash- ing inside and outside with a garden hose. After hosing the cartridge, for best results, allow cartridge to dry and then using a stiff nylon brush, carefully brush pleated surface areas to remove fine particles. 1...

  • Page 6

    5 19. Reinstall tank lid: clean and lightly lubricate o-ring with silicone lubricant. Clean o-ring flange sealing surface on filter lid and place over bottom tank o-ring, pressing down firmly and evenly to seat the filter lid in place. 19. Reinstalacion de la cabeza del tanque: limpie y lubrique lig...

  • Page 7

    6 drain plug mar 21. Install drain plug, open pool suction and return valves and proceed as in initial start-up of the filter, step 10, page 3. 21. Instale el tapon de desague, abra las valvulas de succion y de retorno de agua a la piscina y proceda de la misma forma que se indica en poner en marcha...

  • Page 8

    7 14b 13 1e 2 3 4 5 14f 14g 14e 6 7 8 9 11 12 14d 14a 15a 10 14 1d 1a 1c 1 1f 1h 1g 15b 15c 15d 15 14c 1i 1j 1b crystal water/aqua clear cartridge filter replacement parts diagram cartridge filter replacement parts tem part no. Description 1 g 550-4240 pressure relief valve assembly 1a 602-4211 serv...

  • Page 9

    Important information: read and follow all instructions: algae is a form of plant life which can vary in size from a few thousandths of an inch to the size of a small tree. Of the many forms of algae, the one most frequently found in the swim- ming pool water are microscopic in size and green in col...

  • Page 10

    9 effective design maximum required filtration area flow rate working pressure clearance area efectiva regimen de presion maxima despeje requerido de filtracion flujo nominal de trabajo side above lateral por encima ft 2 m 2 gpm lpm psi bar in cm in cm 570-0250 250 23.2 75 284 50 3.45 6 16 11 28 mod...

  • Page 11: Installing Body O-Ring

    1. Empieze de atras (lado opuesto del fitting) ponga el empaque al rededor de la tapa del filtro y recorralo hacia usted poniendo el empaque entre el dedo pulgar y el dedo indice. 1. Start at back (opposite side from fittings), place o-ring around lip of filter and draw it toward you putting o-ring ...