Watkins Caldera Spa Vacanza Series Owner's Manual - Hydrotherapy Jets
hYdROThERAPY JETS
AdaptaFlo
®
Jets – The larger jets in your spa allow you to re-direct the jet stream by changing the position of the nozzle.
You can also regulate the force of the massage by rotating the jet face clockwise to reduce the force or counter-clockwise to increase the force. Notice that turning off
the flow to some jets increases the flow to the other jets. To avoid damage to your spa’s plumbing and components,
do not turn off more than half of these jets at the
same time.
AdaptaSsage
®
Jets – These jets provide a rotating massage pattern.
Euro Directional Jets – The Euro Directional jets, with eyeball nozzles, deliver a direct, more focused massage. The Euro-Pulse
®
jet features a special insert that creates
a soft, pulsating, rotary massage.
WATERFALL VALVE
The Palatino
TM
and Marino
TM
spas are equipped with a cascading waterfall feature. It is activated by pressing "JETS" button up to 3 times and turning the valve, located on
the front interior wall, counterclockwise. The flow is regulated by turning the waterfall valve to the desired position.
CONTROl OPERATION
(CIMA
™
& lINA
™
SPA MOdElS)
Your control panel consists of an LED display and convenient touch pads that allow you to set the water temperature and adjust the skim/filter cycle settings as well as
control the hydrotherapy jets, and light from spa-side.
lEd dISPlAY
The LED display on your spa-side control panel continually shows the spa’s
actual water temperature. In certain situations, it will also display other
messages. See TROUBLESHOOTING section.
TEMPERATURE CONTROl
The set temperature range is from 60°F (15.5°C) to 104°F (40°C).
Temperatures of any setting may rise slightly depending on the current use
and condition of your spa, and on outside temperature. Whenever power is
disconnected and then reconnected to the spa, the water temperature setting
will automatically return to the default temp of 100º F (38º).
Pressing the Up (
5
) button displays the spa’s set temperature and
illuminates the Up/Down LED for 3 seconds. To increase the set temperature,
press the Up (
5
) button again (before the Up/Down LED turns off), once for
each degree of increased temperature desired. If you hold the button down,
the set temperature will increase by one degree every half second.
Pressing the Down (
6
) button displays the spa’s set temperature and
illuminates the Up/Down LED for 3 seconds. To decrease the set temperature,
press the Down (
6
) button again (before the Up/Down LED turns off), once for each degree of decreased temperature desired. If you hold the button down, the set
temperature will decrease by one degree every half second.
The heater LED will illuminate when the heater is on. If the heater LED flashes on and off, this indicates there is a call for heat but the heater is not yet on.
JET PUMP CONTROl
Pressing the "JETS" button changes the jet pump functions, depending on the number of presses:
CIMA SPA MOdEl ONlY:
1st press:
Two-speed jet pump runs on low speed
2nd press:
Two-speed jet pump runs on high speed
3rd press:
One-speed and Two-speed jet pumps run on high speed
4th press:
One-speed jet pump runs on high speed
5th press:
Both jet pumps are off
19
OPERATING INSTRUCTIONS
Jets Button
Light Button
Temperature Up Button
Temperature Down Button
Temperature Display
Jets Pump LED
Light LED
Filter Cycle LED
Up/Down LED
Heater LED