Watkins Hot Spot Owner's Manual - Everfresh
Page 20
Water Quality and Maintenance
EVERFRESH
®
WATER CARE SYSTEM
The EverFresh water care system is comprised of the FreshWater
Ag+
silver ion system and the FreshWater
®
III high output ozone system.
•
FreshWater
Ag+
silver ion System (see FreshWater
Ag+
silver ion system on previous page)
•
FreshWater III high output ozone system uses Corona Discharge technology to produce a high concentration of
ozone, which is injected into the spa water.
FRESHWATER
Ag+
®
SILVER ION PURIFIER REPLACEMENT INSTRUCTIONS
When replacing the FreshWater
Ag+
silver ion purifier (every four months), it is highly recommended that the spa be drained and refilled at the same
time. After refilling the spa with water, balance the Total Alkalinity (TA), Calcium Hardness (CH) and pH to the recommended levels. Shock the spa
by adding sodium dichlor.
1. Release the cover locks and fold back the cover.
2. Remove the filter compartment cover.
3. Make sure the filter compartment is clear of any floating objects.
4. Drain the spa using the recommended procedures found in the Owner’s Manual.
PLEASE NOTE: The FreshWater
Ag+
silver ion purifier cannot be used with bromine, sodium bromide or biguanides. If you have previously used
any of these products in the spa, it is recommended that the shell and filter compartment be cleaned. It is also recommended that the filters be
cleaned with a filter cleaner before the FreshWater
Ag+
silver ion purifier is installed. (Review the shell and filter cleaning procedures.)
5. Push down slightly and turn filter basket counterclockwise to unlock, then pull out the basket and weir.
6. Grab handle and lift filter straight up and out.
HOT SPOT
®
WATER TREATMENT GUIDE
At spa start-up or refill
Follow spa Start-Up and Refill Procedures.
NOTE: Use the FreshStart
®
10,000
pre-filter when filling the
spa to remove unwanted contaminants.
Prior to each use
(Test before adding any chemicals; do
not add any chemicals if proper or
higher levels are found.)
Once a week
Every four months
Drain and refill your spa.
Replace the FreshWater
Ag+
®
silver ion purifier.
NOTE: Use the FreshStart
10,000
pre-filter when filling the
spa to remove unwanted contaminants.
As needed
(If water is hazy, cloudy or has an odor)
Add one and one half (1-1/2) teaspoons of
sodium dichlor per 250 gallons (950 liters).
Mallorca
2-1/4 teaspoons
Sorrento
1-3/4 teaspoons
Trinidad
1-3/4 teaspoons
Tobago
1-1/2 teaspoons
*MPS is an oxidizer, not a sanitizer.
Add one (1) tablespoon of monopersulfate
(MPS)* per 250 gallons (950 liters).
Mallorca
1-1/2 tablespoon
Sorrento
1-1/4 tablespoon
Trinidad
1-1/4 tablespoon
Tobago
1 tablespoon
Add one-half (1/2) teaspoon of sodium dichlor
per 250 gallons (950 liters).
Mallorca
TM
3/4 teaspoon
Sorrento
TM
2/3 teaspoon
Trinidad
TM
2/3 teaspoon
Tobago
TM
1/2 teaspoon
OR
Add three (3) tablespoons of monopersulfate
(MPS)* per 250 gallons (950 liters).
Mallorca
4-1/2 tablespoons
Sorrento
3-3/4 tablespoons
Trinidad
3-3/4 tablespoons
Tobago
3 tablespoons
Add one and one half (1-1/2) teaspoons of
sodium dichlor per 250 gallons (950 liters).
Mallorca
2-1/4 teaspoons
Sorrento
1-3/4 teaspoons
Trinidad
1-3/4 teaspoons
Tobago
1-1/2 teaspoons
OR