Wattbike ATOM User Manual - page 14
14
0 6
The Atom is constructed from high performance components, and is designed to
withstand heavy usage, making it almost maintenance-free.
If you notice any unusual/loud noises or grinding during operation, stop using
your Atom and contact Wattbike for support.
Do not use corrosive or abrasive materials to clean the equipment.
A F T E R E A C H S E S S I O N
To ensure your Atom stays in good condition, after each session remove all sweat,
dust, dirt and any other substances.
Always use a clean, soft cloth and a non-abrasive liquid cleaner - we recommend
the Wattbike Muc-Off Care Pack.
Wipe down the exterior covers and frame, saddle, and handlebars. Ensure that
the handlebar stem and saddle stem do not exceed the max markers.
M O N T H L Y M A I N T E N A N C E
Where necessary:
• Vacuum the floor under and around the Atom to prevent the bike from picking
up dust.
• Inspect the feet bolts, saddle and handlebar sliders and device holder for
looseness and corrosion. Tighten as necessary.
• Inspect the saddle and handlebar stem adjustments. Tighten as necessary.
• Check that the pedals are secure and fit for use.
• Ensure that no sweat/liquid is pooling on the metalwork or covers.
M O V I N G A N D S T O R I N G Y O U R A T O M
Before attempting to move your Atom ensure all levers and bolts are tight. Failure
to do so may cause injury.
1. Ensure the path to your destination is free from trip hazards that could cause
harm or damage to yourself or the Atom.
2. Turn the Atom off at the switch and wall outlet and unplug from the mains
supply. Place your hands on the handlebars of the Atom and pull towards you
to balance the weight on the coaster wheels.
3. Roll the Atom on the wheels to its destination.
4. If the Atom is not being used for an extended period of time, ensure it is
unplugged and covered with a sheet to reduce damage from dust
and moisture.