Wattbike Exercise Bike User Manual - page 21
21
Logcard
The WPC Logcard (CCL) is a smart card. When loaded into the WPC,
through the slot on the right hand side it captures all the data from
a workout – the workouts can be recalled to ReRide against on
another occasion.
It is recommended that data is transferred directly from the WPC
to the PC using a USB cable (see the Wattbike Expert Software
User Manual).
The Logcard memory is sufficient to store six individual Custom
workouts and 58.5 hours (3,510 minutes) of data. This gives a
greater memory capacity than the WPC itself.
Battery
The Wattbike is fitted with a generator that recharges the battery
when cycling at a cadence over 50 r/m. This means that close to
98% of the working time will be covered with current from the
generator. The batteries should be recharged every month using
the external battery charger supplied with Wattbike. The WPC
can only operate with the original factory supplied accu-batteries
– please contact your Wattbike distributor if you experience any
battery problems.
See Section 5. Preventative Maintenance and Troubleshooting
on page 22 for further battery charging instructions.
Sockets
There are four sockets on the back of the Wattbike Performance
Computer
• SENSOR–toconnecttheWPCtotheWattbike
• CHARGE–toconnectthe12Vbatterychargeadapter
• HEARTRATE–toconnecttoaPolarheartratereceiver
• USB–toconnecttheWattbiketoaPC(do not use a USB
cable of more than 3m in length)
• RESETbutton–seeSection5.PreventativeMaintenance
and Troubleshooting
Where the ‘no hands’ symbol is displayed do not touch the
connectors on the back of the Wattbike Performance Computer
with your hands unless your body has been discharged of static
electricity.