Wattbike Exercise Bike User Manual - page 8
08
A-Attachrearfoot
Lift up the rear of the Wattbike to an angle of approximately
30 degrees – donotsupporttheweightoftheWattbikeon
thefancage. You will need an assistant to hold the bike in this
position whilst you fit the rear foot.
Thread the 2 holes of the rear foot onto the lugs on the Wattbike
frame. Secure with 2 x 17 mm hex bolt head 25 mm screws and
washers - tighten securely with a 17 mm spanner.
GentlylowertheWattbiketothefloor.
B-Attachfrontfoot
Lift up the front of the Wattbike so that the weight is supported
on the back foot – you will need an assistant to hold the bike in
this position whilst you fit the front foot.
Thread the 2 holes of the front foot onto the lugs of the Wattbike
frame with the wheels facing forward. Secure with 2 x 17 mm hex
bolt head 25 mm screws and washers - tighten securely with a 17
mm spanner.
Gently lower the Wattbike to the floor.
C-Attachpedals
Screw the right pedal onto the right crank - tighten securely using
a 15 mm spanner. Repeat for the left pedal.