Wattbike Pro Assembly & Service Manual - 7. Calibration
6. Preventative Maintenance and Troubleshooting
The Wattbike is constructed from high performance components and is designed to be almost maintenance free and should
withstandheavyusage.Ifyounoticeanyunusualsymptoms,suchasloudnoisesorgrindingduringoperation,stopusingyour
Wattbike and contact your local Wattbike distributor.
Foranormalserviceallthatisrequiredis5mm,6mmHex(Allen)Keys.
Donotusecorrosiveorabrasivematerialstocleantheequipment.Ensurethatsuchmaterialsarenotallowed to pollute the
environment.
Daily Maintenance
ToensureyourWattbikestaysinfirstclassconditionremoveallsweat,dust,dirtorothersubstancesbyusingaclean,softcloth
and a non-abrasive liquid cleaner.Wipe down the exterior covers and frame, saddle, handlebar andWattbike Performance
Computer.
Make sure that the handlebar stem and saddle stem are not over the MIN markers.
Weekly Maintenance
Vacuum the floor under and around the Wattbike.
Inspectthefeetscrews,saddleandhandlebarslidersandWattbikePerformanceComputerbracketforlooseness.Tightenas
necessary.
Inspect the saddle and handlebar stem adjustments. Tighten as necessary. Check that the pedals are secure. Tighten as necessary.
Ensurethatnosweat/liquidispoolingonthemetalworkorcovers.
Check that the battery level on the WPC is high or medium. Go to SET UP then PROPERTIES to check and use the supplied
charger if battery reads low.
Monthly Maintenance
Checkforsmoothandquietoperationofallmovingparts.
Check your WPC firmware version - go to SET UP then PROPERTIES. Compare to the latest WPC firmware version at wattbike.
com and update if necessary.
Six Monthly Maintenance
Toolsneeded2.5mmHex(Allen)Key,alongandthincross-headscrewdriver,15mmspanner.
Lubricate the chain and check that internal parts are moving freely. You will need to remove the right side cover to lubricate
thechain,thiswillnotinvalidateyourwarranty.Todothis:removethemagneticresistanceknobandspinthisdownbelowthe
cover;removethe12screwsattachingthecover;removetherightpedal.Thecoverwillnowcomeawayandofftheframe.
Lubricatethechainwiththeagrease,makesurethatallthemovingpartsarerunningsmoothlyandremoveanydust/materials
from the area.
Replacethecover,pedal,screwsandmagnetic-resistanceknob
7. Calibration
The Wattbike is factory calibrated and does not need further calibration. It is recommended that you set the zero state before
each use by:
Select Setup from the Main menu then Memory and simultaneously press all four buttons.
RotatethepedalsbackwardsforafewrevolutionstounloadtheWattbike.Thecranksshouldbeunladenedandinahorizontal
position.
Press ENTER–themonitorwillautomaticallysetzero.
The Wattbike Warranty and Regulatory Information can be found at wattbike.com/warranty