WattBox WB-200-IW-2 Owner's Manual - page 4
pg.4
WB-200-IW-2-WHT Installation and Users Manual
IMPORTANT SAFETY INSTRUCTIONS
Read and observe the following safety points at all times:
WARNING – TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE
WARNING – POWER SOURCES
• The WB-200-IW-2 is rated for use with only 125 volt / 15 amp circuits.
• Install with a minimum of 14 AWG building (e.g. Romex®) electrical wire.
• Do not overload wall outlets as this can result in a risk of fire or electric shock.
WARNING - REPAIR
• Do not attempt to service the WB-200-IW-2. Refer all servicing to qualified service personnel. Servicing is required when the
WB-200-IW-2 has been damaged in any way, such as being exposed to rain or moisture, or LEDs do not illuminate when
connected to main electrical service.
• No User Serviceable Parts Inside. If, for any reason, your WB-200-IW-2 is not operating properly, do not attempt to open
casing for repair. Turn off the circuit breaker feeding electric power to the outlet and consult this owner’s manual for warranty
and service information.
• When replacement is required, be sure the service technician is a licensed electrician.
• Upon completion of any service, ask the electrician to perform safety checks to determine that the product is in proper
operating condition prior to use.
• If you have any difficulty operating the WB-200-IW-2, refer to the warranty information contained in this owner’s manual.
WARNING – LIQUID: AVOIDING ELECTRICAL SHOCKS
Do not operate the Component if liquid of any kind is spilled onto or inside the unit. Do not operate the Component near rain or
water that’s spilled or contained (e.g. sink or bathtub).
WARNING – NO USER SERVICEABLE PARTS INSIDE
If, for any reason, the Component is not operating properly, do not remove any part of the unit (cover, etc.) for repair. Contact
an authorized WattBox dealer for information on service and repairs. Please consult the Warranty Information section of this
owner’s manual for important details.
CAUTION – EXPOSURE TO HEAT
Do not expose the Component to direct sunlight or place it near wall heaters, space heaters, or any enclosed space prone to
temperature increase.
CAUTION – PROPER CLEANING
In general, the only cleaning necessary for the Component is a light dusting. Unplug the Components from the WB-200-IW-2
outlets before cleaning it. Do not use any type of liquid or aerosol cleaners.