Watts Clever EW4006 Instruction Manual - page 2
3
Fig. 2
Notes on Safety
Parts and Usage
Caution
●
Do not allow conductive materials such as rings, bracelets or keys to touch
the batteries, otherwise a short circuit may cause the batteries and / or
conductive material to overheat and cause burns.
●
Do not connect any part of The
WIRELESS Energy Monitor
directly to the
electrical supply. The
WIRELESS Energy Monitor
Sensor Clips around the
outside of your existing electricity meter wire.
●
Do not locate the Power Transmitter, Sensor Clip, its lead or the Energy
Monitor within reach of children.
●
Do not locate any part of the product or its leads near heat sources such as
radiators, cookers, etc.
●
Do not use outdoors, in a bathroom, near water or in areas subject to high
moisture levels.
●
Do not let the Sensor Clip lead lie or hang where it could be pulled on or
tripped over accidentally.
●
Do not use The
WIRELESS Energy Monitor
for other than the intended use.
●
Do not open the product other than to replace the batteries using the slide
off battery covers.
●
Do not use this product near emergency / intensive care medical equip-
ment.
●
Do not use this product where the use of radio frequency products can
cause malfunction in other equipment (for instance hospitals, aircraft, etc)
●
Do not allow liquids to spill into the units or subject the units to excessive
smoke, dust, mechanical vibration or shock.
●
Do not dispose of old batteries in a fire as they may explode.
●
Do not open or mutilate the batteries. Released electrolyte from the bat-
teries is corrosive and may cause burns or injury to the eyes or skin. The
electrolyte may be toxic if swallowed.
●
Do not rely on the displayed information to calculate the cost of your elec-
tricity bill. The
WIRELESS Energy Monitor
is an educational device and is
not intended to replace your energy supplier’s energy meter.
Installation
The
WIRELESS Energy Monitor
Sensor Clip fits
around one of your electricity meter wires with-
out any requirement for a direct electrical con-
nection.
UNDER NO CIRCUMSTANCES SHOULD YOU REMOVE THE PLASTIC INSULA-
TION OF YOUR ELECTRICAL INSULATION WIRES.
The
WIRELESS Energy Monitor
is a passive device and
does not require a direct connection to the electricity
supply. Installation by a qualified electrician is not re-
quired. Please ensure you have read the Important Safety
Information at the beginning of this manual before install-
ing this product.
Locate your electricity meter. There are many different
types of electricity meter and your property may be fitted
with an older mechanical meter, or a newer digital meter
as shown (Fig. 2). If you are not sure the meter may typi-
cally be identified from other electrical equipment as it
will have a numeric display or dials indicating the current
meter reading.
First, without touching anything, inspect the electrical
wires for any signs of damage to their protective plastic
insulation.
If you can see any damage or any exposed inner metal
cores of the wires do not touch - seek expert advice be-
fore installing The
WIRELESS Energy Monitor
.
Find a suitable location for the Sensor Clip from which
the sensor clip cable will reach to the electricity meter.
The location should ideally be away from any large metal
objects as this may affect radio range. If desired you may
fit a screw to your wall and fix the Sensor Clip to it using
its rear screw fixing slot.
Fig. 1
LCD display
1
Reset
3
Mode
2
Pair
4
Energy
Monitor
Power Transmitter
Sensor Clip
Disp
5
Set
6
Up
7
Down
8
2