Watts Clever EW4006 Instruction Manual - page 4
Display Mode
Power
Press the [
Mode
2
] button once. Each time you press it will cycle through
showing [
POWER
] – [
COST
] – [
CO
2
] in the display.
Press the [
Disp
5
] button and the currently displayed mode will change be-
tween showing [
HIGH
] / [
LOW
] costs for the day, and MONTH and YEAR
totals to date.
●
At 24.00hr each day the high and low figures with go back to zero.
●
At 24.00hr on the last day of each month the monthly figure will revert to
zero.
●
At 24.00hr on the 31st December the yearly figures will revert back to zero.
To delete all information and reset all figures to zero then press and hold the
[
Reset
3
] button for 5 seconds with a pencil or other pointed object.
Cost
CO
2
Important Information
Before installing and using your new
WIRELESS Energy Monitor
please take
time to familiarise yourself with the important safety information, installation
guide and set-up instructions.
Mains voltage electricity is dangerous and can kill. If you are unsure about the
quality or safety of your electrical installation obtain professional advice from
an electrician prior to installing The
WIRELESS Energy Monitor
.
The
WIRELESS Energy Monitor
Sensor Clip is fitted around one of your elec-
tricity meter wires without any requirement for a direct electrical connection.
UNDER NO CIRCUMSTANCES SHOULD YOU REMOVE THE PLASTIC INSULA-
TION OF YOUR ELECTRICAL INSTALLATION WIRES.
DO NOT approach damaged, loose or exposed electrical cabling. If you notice
anything unusual such as burn marks, holes in the insulating materials or dam-
age to the meter.
DO NOT install your
WIRELESS Energy Monitor
and contact your electricity
provider immediately.
Multi-tariff Users
This product is designed as a simple and cost effective way to monitor your
electricity usage and to understand how to lower you energy usage and costs.
To keep the operation as simple as possible we have not included the option
to enter different sets of tariff for your energy use. If you have 2 or more tariffs
then we recommend you enter the higher tariff. You will still be able to assess
the rise and fall in energy use and what the impact of turning on and off ap-
pliances.
Battery Replacement
If the batteries are running low in the transmitter unit then the battery 1 sign
will flash on the display screen. If the batteries are running low in the Energy
Monitor then the battery 2 sign will flash on the display screen.
When you remove and replace the batteries you will have to re-pair the trans-
mitter and Energy Monitor and re-enter the initial data again.
7
6