Watts Premier HT-5-VOC-B Installation, Operation And Maintenance Manual - Adapt-A-Valve Installation
Page 7
Turn off the cold water supply to the faucet by turning the angle stop valve completely off.
Open cold water sink faucet to relieve pressure.
Step 9
Step 10
Choosing the configuration that fits your plumbing, attach the adapt-a-valve as illustrated in
the four photos above.
Adapt-a-Valve Installation
Do not use Teflon tape with the Adapt-a-Valve.
WARNING:
Caution:
Water supply line to the system must be from the cold water
supply line only. Hot water will severely damage your system.
3/8” Configuration
(With Brass Fittings)
* Insert White Washer
1/2” Configuration
(Without Brass
Fittings)
*
White
Washer
Hot
Supply
Cold
Supply
Hot
Supply
Cold
Supply
Verify contents prior to installation:
( 1 ) - Plastic Adapt-a-Valve with black collet
( 1 ) - Brass Adapter no washer
( 1 ) - Brass Adapter with black washer
( 1 ) - White rubber washer
Make sure that the black collet is installed in to the 1/4” opening on the Adapt-a-valve.
Don’t forget to install the white compression washer with the 3/8” configuration.
Brass adapter (A) does not need to be tightened with a wrench, only finger tight.
Black
Collet
A
TIPS:
A
White
Washer
How to use the Quick Connect Fittings
To make a connection, the tube is simply pushed into the fitting. The unique locking system holds the tube firmly in place
without deforming it or restricting flow. Use the steps below in reference to any quick connect tube connections.
It is essential that the outside diameter be free
of score marks and that burrs and sharp edges
be removed before inserting into fitting.
Fitting grips before it seals. Ensure tube is
pushed into the tube stop.
Push the tube into the fitting, to the tube stop.
The collet (gripper) has stainless steel teeth
which hold the tube firmly in position while the
O-ring provides a permanent leak proof seal.
Pull on the tube to check that it is secure. It is a
good practice to test the system prior to leaving
site and /or before use.
To disconnect, ensure the system is
depressurized before removing the tube.
Push in the collect squarely against face of
fitting. With the collet held in this position,
the tube can be removed. The fitting can
then be reused.