Page 1 installation, operation and maintenance manual deluxe plus premier 25 ultra 5 ro-tfm-4sv ro-tfm-5sv pur-tek refer to enclosed warranty for operating parameters to ensure proper use with your water supply. Watts premier, inc. 1725 w. Williams drive c-20 phoenix, az 85027 phone: 800-752-5582 ww...
Page 2 this page has been left blank intentionally..
Page 3 thank you for your purchase of a state of the art watts premier reverse osmosis (ro) water treatment system. Water quality concerns are becoming more of a focus for the public. You may have heard about contaminants in the drinking water, such as arsenic, chromium, cryptosporidium or giardia. ...
Page 4 with proper installation and maintenance, this system will provide you with high quality water for years to come. All of premier’s water enhancement products are rigorously tested by independent laboratories for safety and reliability. If you have any questions or concerns, please contact our...
Page 5 do not use with water that is micro biologically unsafe or of unknown quality without adequate disinfection before or after the system. System is intended to be installed on the cold water line only. 1 tank – blue or white 1 module – blue or white (filters pre-installed) 1 parts bag – with a ...
Page 6 make sure the surroundings of the sink are cooled before mounting the faucet to the sink after drilling and remove all sharp edges. Step 3 step 4 determine desired location for the ro faucet on your sink and place a piece of masking tape over where the hole is to be drilled. Mark the center o...
Page 7 remove nut (item 11) and blue tubing (item 12) from faucet (leave the nut and plastic delrin sleeve (item 10) on the blue tube). Feed both the red and black tubing through the pre drilled hole in the sink/counter until faucet is seated. Step 7 under the sink - on to the threaded faucet stem i...
Page 8 adapt-a-valve installation - part# 134007 turn off the cold water supply to the faucet by turning the angle stop valve completely off. Step 11 step 12 attach the adapt-a-valve as illustrated in the three photos above, choosing the configuration that fits your plumbing. (when attaching the adapt...
Page 9 drill hole and connect 3/8” black tube from faucet to the drain saddle measure the 3/8” black tube from faucet to the drain saddle on the drain pipe and make a straight cut to the correct length. Slip black tube through black compression nut. Insert black tube into the opening in the drain sa...
Page 10 thread the brass tee (supplied in the parts bag) onto the brass connection on the top of the tank and tighten using an adjustable wrench. Step 1 step 2 teflon tape must be applied in a clockwise direction. Wrap 7 to 12 turns around the male pipe threads (mpt) on the stainless steel fitting on ...
Page 11 remove the seal caps from both ends of the final filter. Cut the blue tubing between the ro faucet and the storage tank at a desired location to splice in the in-line final filter. Step 1 thread the two white plastic connectors into the final filter and tighten with a wrench. Do not overtighten th...
Page 12 start up instructions register by phone, fax, mail or internet. Watts premier uses this information only to provide you with a filter change reminder service. Pre-filters should be changed every 6 months and the final in-line filter annually. You may register your system via our web site at www....
Page 13 6 month system maintenance step 1 step 3 let system sit for a few minutes after the tank is empty to let the system depressurize before attempting to remove filter housings. Items needed: √ stage 1 - sediment filter (part #: 104017) √ stage 2 & 3 - carbon block filter (part #: 101009-white en...
Page 14 annual maintenance step 1 √ stage 1 - sediment filter (part #: 104017) √ stage 2 & 3 - carbon block filter (part #: 101009-white end caps) √ stage 5 - 10” final polishing filter (part # 560010) √ 1/2 cup of hydrogen peroxide or 2 tablespoons of common household bleach. *order filters by callin...
Page 15 membrane replacement use a 5/8” wrench to remove the green tube fitting on the left side of the horizontal membrane housing (end with one elbow). Step 1 step 2 step 3 step 4 step 5 note: this reverse osmosis system contains a replaceable component (the ro membrane) which is critical to the ef...
Page 16 once all water in the tank is purged, check air pressure using an air pressure gauge, it should read between 5 - 7 psi. (digital air pressure gauge is recommended) check air pressure in the tank important: step 3 check air pressure only when tank is empty of water! Step 1 turn off the incomi...
Page 17 trouble shooting problem cause solution 1. Low/slow production low water pressure assure a minimum of 40 psi incoming water pressure. Premier sells a booster pump if home water pressure is low. Make sure water supply is turned on and adapta valve is all the way open. Crimps in tubing check t...
Page 18 item # part # description 15 125041 union-pl-1/4cx1/4c 16 131002 nut-br-1/4c” 17 131012 sleeve-plastic-1/4” 18 131017 insert-brass-1/4” 19 131021 hex nipple-brass-1/4 20 131023 tee-tank-brass-1/4cx1/4cx1/4f 21 134003 valve-shut off 1/4mpt quick connect 22 134007 adapta valve 22 a 146025 adap...
Page 19 california certification state of california department of health services water treatment device certificate number 1452 date issued: october 17, 2005 trademark/model designation 00 - watts premier deluxe plus watts premier ultra 5 watts premier pur-tek watts premier watts 25 watts premier r...
Page 20 recommended replacement parts and change intervals: note: depending on incoming feed water conditions replacement time frame may vary. Description change time frame cost sediment pre-filter: #5m-10 6 months $ 3.50 carbon pre-filter: #5mcb 6 months $10.50 final carbon filter #1m-6/#1m-10 12 mont...
Page 21 arsenic (as) is a naturally occurring contaminant found in many ground waters. Arsenic in water has no color, taste or odor. It must be measured by an arsenic test kit or lab test. Public water utilities must have their water tested for arsenic. You can obtain the results from your water uti...
Page 22 50 gpd membrane compatible with watts premier reverse osmosis systems, this 50 gpd membrane generates a greater amount of water per day for your ro system. Good application for households with higher levels of nitrites & nitrates. Contact watts premier if you are in need of a nitrite/nitrate...
Page 23 whole house high performance water pressure regulator provides water pressure control solutions for residential, commercial, and indus- trial applications. Offers durability and years of continuous trouble free operation. Part no. 107001 *$69.95/ea water pressure gauge this gauge mounts onto...
Page 24 removing chlorine from your shower deluxe shower handle with built in filter replacement filters 2pk 5-way massaging spray 72” reinforced hose high strength bracket triple plated finish reversible filter cartridge (model hhc) cartridge life rating: 3 months part no. 107070 white *$38.95 part ...
Page 25 4 ways to register 1. On-line at www.Wattspremier.Com 2. Call in your information 1-800-752-5582 3. Fax in your information 623-931-0191 first name:_________________________ last name:____________________________ address: ________________________________________ city: ____________________ st...
Page 26 warranty registration please fill out and keep for your records insert into envelope and return to watts premier first name:_________________________ last name:____________________________ address: ________________________________________ city: ____________________ state: ___________________...
Page 27 service record date of purchase:__________ date of install:___________ installed by:__________________ notes: date 1st stage sediment (6 months) 2 nd stage carbon (6 months) 3rd stage carbon (6 months) final filter carbon (1 year) tfm membrane (2-5 years).
Page 28 limited warranty what your warranty covers: if any part of your watts premier reverse osmosis system is defective in workmanship (excluding replaceable filters and membranes), return unit after obtaining a return authorization (see below), less tank, within 3 years of original retail purchase...
