Watts Premier RO-PURE Installation, Operation And Maintenance Manual - page 8
WATTS Premier Chrome Monitored & Non-Monitored
(Top Mount) Faucet Installation
Minimum
Maximum
Mounting Hole Size
1.00”
1.25”
Torque on Toggle Bolt
5lb.in. (max)
Step 6
Step 7
Step 8
Step 9
Gather and identify the faucet pieces.
Remove faucet base & faucet spout from their respective
plastic bags. From above the sink, feed the faucet base,
tubing & toggle bolt down through the 1
¼” mounting hole in
the sink.
Align the faucet base so that the handle is on the
right side and the base is sitting flush on the sink top.
Ensure that the soft rubber gasket is uniformly positioned in
between the base and the top of the sink.
Lift faucet base and remove the white paper from the
gasket and stick it to the top of the sink in the appropriate
position for the faucet base. Turn the handle down (towards
you) to the “ON” position to reveal the tightening screw
(located where the spout will be inserted). Using a phillips
head screwdriver, turn the screw clockwise until the toggle
bolt secures the faucet base snug onto the sink top, do not
over torque toggle bolt (5lb.in. max)
Once the faucet base is securely fastened to the sink top,
insert the faucet spout into the faucet base until it is fully
seated. Turn the handle up (vertical) to the “OFF” position.
Completion of faucet installation (tubing connections) will be done
later in this manual. Refer to the Black Tube Connection
(page 12), Red Tube Connection (page 13), and Blue
Tube Connection (page 12) sections of this manual.
If your faucet is equipped with the monitoring function please proceed to the next step,
otherwise please proceed to the next page.
Faucet Battery Installation
Step 10
Insert the battery drawer with the battery into the base of the faucet until it is
fl
ush.
NOTE: The + side of the battery faces up. The compartment drawer will not slide in if the battery is installed
upside down.
When the battery is first installed, both the red and green lights will flash to indicate that both lights are functional.
Thereafter, it will flash green only when the faucet handle is turned to the “ON” position. When your system is ready to be
serviced (approximately six months) you will see the light flash red when the handle is turned to the “ON” position. Refer to
the Six Month Maintenance (page 14) section of this manual forfilter replacement.
NOTE: If your water usage is high the red light may activate sooner than six months indicating the need for filter
replacement.
This faucet provides an electronic monitor that will tell you when it is time to replace the filters in your water
treatment device. The light indicator will be green for the life of the filter, turning red once the life of the filter
has been reached. This can occur after six months of use, or sooner for heavy water usage. To reset the
electronic monitor during replacement of filters, simply slide out the battery from the faucet and reinsert. The
battery life is expected to last one year, however, for heavy use the battery may need to be replaced sooner.
For replacement, look for battery number CR2354 (Watts p/n:116082) which is available at your local battery
store or contact Watts Premier at 800-752-5582. You can also order online at www.wattspremier.com.
Page 8