Watts Premier WP-4V Installation, Operation And Maintenance Manual - (P/n 116174)
Page 6
Remove faucet base & faucet spout from their respective
plastic bags. Feed the faucet tubing through the round
rubber gasket which you will find in the faucets parts bag.
Peel the white backing from the upper side of the gasket
and press firmly on to the base of the faucet. From above
the sink, feed the faucet tubing & toggle bolt down through
the 1
¼” mounting hole in the sink.
Peel the white backing from the bottom side of the rubber
gasket, align the faucet base so that the handle is on the
right side and press the faucet base down firmly over
the mouting hole. Turn the handle down (towards you) to
the “ON” position to reveal the tightening screw (located
where the spout will be inserted). Using a Phillips head
screwdriver, turn the screw clockwise until the toggle bolt
secures the faucet base snug onto the sink top, do not
over torque toggle bolt (5lb.in. max)
Once the faucet base is securely fastened to the sink
top, insert the faucet spout into the faucet base until it is
fully seated. Turn the handle up (away from you) to the
“OFF” position.
Completion of faucet installation (tubing connections) will
be done later in this manual.
Remove the faucet battery from the plastic bag. Locate
the faucet battery compartment drawer on the base of the
faucet. Use a small screwdriver to pry on the notch at the
compartment drawer face and slide the drawer out. Insert
the battery into the battery compartment drawer.
NOTE: The + side of the battery faces up. The compartment drawer will not slide in if the battery is installed upside
down.
Once the battery is in place, slide the battery compartment drawer back into the base until it is flush.
When the battery is first installed, both the red and green lights will flash to indicate that both lights are functional. Thereafter,
it will flash green only when the faucet handle is turned to the “ON” position. When your system is ready to be serviced
(approximately six months) you will see the light flash red when the handle is turned to the “ON” position.
NOTE: If your water usage is high the red light may activate sooner than six months indicating the need for filter
replacement.
This faucet provides an electronic monitor that will tell you when it is time to replace the filters in your water
treatment device. The light indicator will be green for the life of the filter, turning red once the life of the filter has
been reached. This can occur after six months of use, or sooner for heavy water usage. The battery life is expected
to last one year, however, under heavy use the battery may need to be replaced sooner. For replacement, look
for battery number CR2354 (Watts p/n:116082) which should be available at your local battery store or contact
Watts Premier at 800-752-5582. You may also order online at www.wattspremier.com.
WATTS
Premier Monitor (Top Mount) Faucet Installation
(P/N 116174)
Step 6
Step 7
Step 8
Step 9
Step 10
Faucet Battery Installation
Minimum
Maximum
Mounting Hole Size
1.00”
1.25”
Torque on Toggle Bolt 5lb.in. (max)
Flow Restrictor
Red Tubing (Faucet)
NOTE: Do not cut or shorten the red tubing as this may damage the flow restrictor located inside.
116174