Watts Premier ZERO WASTE RETRO Installation Instructions - Warranty
Warranty
LIMITED WARRANTY: Watts Pure Water warrants each product to be free from defects in material
and workmanship for a period of one year from the date of original shipment. In the event of such
defects within the warranty period, the Company will, at its option, replace or recondition the product
without charge. This shall constitute the sole and exclusive remedy for breach of warranty, and the
Company shall not be responsible for any incidental, special or consequential damages, including,
without limitation, lost profits or the cost of repairing or replacing other property which is damaged if
this product does not work properly, other costs resulting from labor charges, delays, vandalism,
negligence, fouling caused by foreign material, damage from adverse water conditions, chemicals, or
any other circumstances over which the Company has no control. This warranty shall be invalidated
by any abuse, misuse, misapplication or improper installation of the product. THIS WARRANTY IS IN
LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY IMPLIED
WARRANTIES OF MERCHANTIBILITY OR FITNESS FOR A PARTICULAR PURPOSE. Any implied
warranties that are imposed by law are limited in duration to one year.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not
allow the exclusion or limitation of incidental or consequential damages. Therefore, the above
limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may
have other rights that vary from State to State. You should consult applicable State laws to determine
your rights.
page 4
Step 1
Step 2
Step 3
Step 4
Step 5
Turn off hot and cold water supply lines, (close ice maker valve if
it applies).
Unplug the pump from electrical outlet.
Open RO faucet to drain tank, leave faucet open. If unit has a
ball valve on tank close the ball valve and tank does not have to
be emptied.
Follow normal maintenance procedures found in the original RO
manual.
After maintenance is complete turn on hot and cold water supply.
Step 6
Plug pump into electrical outlet.
Step 6
Close RO faucet once water begins to trickle out.
Shut down procedure for filter and membrane maintenance