Wattstopper FS-705 Installation instructions

Summary of FS-705

  • Page 1

    Specifications power supply........................... 24vdc from wattstopper class 2 power pack only current consumption ................................. 7ma@24vdc dimension ........... 3.15” front to back x 2.68” w x 1.77” h (80mm front to back x 68mm w x 45mm h) weight .............................

  • Page 2

    Installation determine an appropriate mounting location for the fs‑705. Mount the fs‑705 on top of the cabinet in the center for equal coverage on either side. Place the front edge of the sensor at the front edge of the cabinet. Secure the sensor to the top of the cabinet with self tapping screws. P...

  • Page 3

    Figure 4: bz‑150 power pack connected to fs‑705 using an fs‑c2 adaptor fs-705 sensor blue red black fs-c2 shielded 6” (152mm) cable with 3 flying leads at one end and a shielded rj45 male connector at the other. Use fs-c5 coupler with fs-c1 or fs-c3 to extend cable. Line neutral load local off switc...

  • Page 4

    Ordering information fs‑705 wide‑angle pir sensor, 24vdc bz‑50 power pack with flying leads for connecting low voltage wires bz‑50rc power pack with rj45 jack for connecting low voltage wires bz‑150 power pack with flying leads for connecting low voltage wires, hold‑on/hold‑off inputs, plus manual o...