1. DL manuals
  2. Wattstopper
  3. Accessories
  4. PW-100
  5. Installation Instructions Manual

Wattstopper PW-100 Installation Instructions Manual

Other manuals for PW-100: Installation Instructions Manual

Summary of PW-100

  • Page 1

    Santa clara, ca 95050 800.879.8585 installation instructions specifications voltages: pw-100 & pw-200. . . . . . . . . . . . . . . . 120/277vac, 50/60hz pw-100-347 & pw-200-347. . . . . . . . . . . . 347vac, 50/60hz load limits for each relay: @120vac. . . . . . . . . . . . .0-800w tungsten or balla...

  • Page 2: Turning Load(S) On (On Mode)

    Unit description and operation the pw passive infrared wall switch sensors use advanced passive infrared (pir) technology. The pw sensor can turn a load on, and hold it on as long as the sensor detects occupancy. After no movement is detected for the selected time delay, the lights switch off. A “wa...

  • Page 3: Presentation Mode

    Test/20 min (dip 1, 2, 3,off) presentation mode is a feature of the auto on mode.When both relays are manually turned off the pw holds the lights off until no motion has been detected for the duration of the time delay. With subsequent occupancy, the pw turns the load on. If both relays are on and o...

  • Page 4: Coverage Patterns

    Call 800.879.8585 for technical support coverage patterns coverage testing has been performed according to the nema wd 7 guideline. For best performance, use in spaces not larger than 15’ x 12’. Pir sensor the sensor has a two-tiered, multi-cell viewing fresnel lens with 180 degree field of view. Th...

  • Page 5: Installation

    1. Make sure that the power has been turned off at the circuit breaker. 2. Connect wires to the pw flying leads as shown in the wiring diagram that is appropriate to the pw model and electrical supply. The 2 ground wires (green and green/ yellow) must be fastened to ground for the sensor to work pro...

  • Page 6: Dip Switch Settings

    Dela y pir 50% wa lk aud. Alert rl y 1 man rl y 2 man vis. Alert on/off buttons relay 1 relay 2 dip switches pir lens detection led dip switch settings =on =off 8 auto on manual on relay 1 mode 5 high low, 50% pir sensitivity 7 disabled enabled audible alert 4 disabled enabled walk-through 9 1 2 3 4...

  • Page 7: Troubleshooting

    Troubleshooting lights do not turn on with motion (led does flash) 1. Press and release each button to make sure that the correct lights come on for each relay. If the lights do not turn on, check wire connections, especially the load connection. If the lights turn on, verify that the correct on mod...

  • Page 8: Warranty Information

    Please recycle 2800 de la cruz boulevard, santa clara, ca 95050 technical support: 800.879.8585 • www.Wattstopper.Com warranty information wattstopper warranties its products to be free of defects in materials and workmanship for a period of five years. There are no obligations or liabilities on the...