WAV SportLine 480 Owner's Manual - Workscertificate
EAL/011-09/98
Aussteller: EAL
Verteiler: Vertrieb, Kunde
Workscertificate
Workscertificate (EN 10204 2.1)
These indicated technical data are based to the form „Artikelspezifikation – Technisches Datenblatt“
Article Valmex
Inflatable boat material
Article - No.: 7311 / 7318 / 7307 / 7321
Resistance to liquids
Carry out the test on the external side or the sides of the material contact with the ambient environment as specified in ISO
1817 but using ASTM Oil No.1.
In cases a) and b) shown in Table 1, the change in mass per unit area shall not exceed 100 g/m² following the stipulated
period of contact with the test fluid at a temperature of 70°C +/- 2°C.
Table 1 – Test liquids
Test liquid Period of contact
a) Oil 22 h +/- 0,25 h
b) Salt water 336 h
Result: pass
Resistance to ozone
Carry out the test on the external side or the sides in contact with the ambient environment as specified in ISO 3011.
Exposure time 72 h
Temperature of test 30°C +/- 2°C
Concentration 50 pphm (= parts of ozone per hundred million of air by volume)
that is to say a volume fraction of 0,5 x 10
-6
Mandrel diameter 5 times the material thickness
There shall be no signs of cracking on completion of the test when the test samples are examined under a magnification of 10
x.
Result: pass
Tear strength
ISO 4674-1 (Dec.2003) Method B: minimum requirements 250 N
Result: pass
Adhesion
ISO 2411 – Adhesion measured as per ISO 2411 – Method HF – Welding:
Minimum requirements 20 N / cm (10 daN / 5 cm)
Result: pass
Resistance to cold
All materials shall satisfy the requirements of ISO 4646 at a temperature of – 15°C.
Result: pass
Mehler Texnologies GmbH
Fulda, den 02.04.07 Wiegard
Technical Department