Wave Fitness Neptune Owner's Manual - page 10
Troubleshooting:
Fault
Probable Cause
Solution
Water changes color or becomes cloudy.
Rower is in direct sunlight or has not had
water treatment.
Change rower location to reduce direct ex-
posure to sunlight. Add water treatment and
blue dye or change tank water as directed
in the water treatment section of this man-
ual.
Rower belt slipping off belt/ bungee pulley.
Bungee not under enough tension.
Tighten bungee cord following the instruc-
tions
given in the change bungee section of
this manual.
Front leg rises slightly during vigorous rowing
M10X180mm vertical seat rail bolt is
slightly too loose.
Tighten bolt 1/2 turn and try again. Tighten
as needed until problem stops. Note: Over
tightening this bolt can damage the seat
rail. Only tighten bolt until rear main frame
leg begins to lift slightly from the ground.
The Neptune Rower computer does not illumi-
nate after battery installation.
Batteries installed incorrectly or need re-
placing.
Reinstall batteries in correct position and try
again. If the LCD screen fails to illuminate,
replace batteries. If this fails, contact your
local service center.
Neptune Rower Computer screen illuminates,
but does not register when rowing.
Loose or failed connection.
Check that the computer lead is connected
properly. If it is connected then contact
your local service center.