Wave Fitness Neptune Owner's Manual - page 4
Assembly Instructions
1.
Install seat (3) on seat rail (2) with indentation facing rearward.
2. Mount rubber bump stop (22),
bevel
edge facing seat with M6X10mm bumpstop screws
(21).
3. Install Rear leg using M10X25mm Bolt (19),11*21*2T Washer (9) and Rear Leg (17).
4. Install 75X50 Rubber end cap (18).
5. Connect sensor lead from Seat Rail to Main frame, and attach Seat Rail to main frame
using M10X95mm Bolt (8), 11*21*2T Washers (9) and M10Nylock Nut (6).
6. Insert vertical rail bolt (4), Plastic dome cap (5), M10 Washer (7) and Nylock Nut (6).
Note: Do not tighten until assembly is complete.
7. Unscrew the right side of the footplate assembly M8X15mm bolt (14), M8 washer (15) and
remove the right footplate (10). Then remove the right Nylon spacer (12) and thread the foot-
plate shaft bolt (11) with Internal Spacer (13) through as shown in Step 7.
Note: Once the rower assembly is complete, tighten the vertical seat rail tensioning bolt until
the rear leg of the main frame is approx 5mm off the floor and just touches during a weighted
rowing stroke. If upon use, the front of the rower displays a desire to “hop” slightly, the verti-
cal seat rail bolt needs to be tightened accordingly.
Step 1
Step 2
Step 3
Step 4
Install Rubber end cap
Step 5
Step 6
Step 7
3
2
21
22
19
17
9
18
6
9
9
8
Sensor lead
6
7
5
4
10
14
15
12
13
11