WaveSense jazz Oweners Manual - [1]
58
59
Time and Date Setting After Battery Replacement
If the date and time need to be set, the word “SET” will be
displayed the first time the meter is activated.
Note: The meter retains the date and time format [24 or 12 hour
time, M-d (Month-Day) or d-M (Day-Month)]
[1]
Set the year (flashing) with the DOWN (
)
or UP (
) arrow buttons. Press the CHECK ( )
button to confirm your selection.
[2]
If in M-d (Month-Day) format, set the month
(flashing) with the DOWN (
) or UP (
) arrow
buttons. If in d-M (Day-Month) format, set the
day (flashing) with the DOWN (
) or UP (
)
arrow buttons. Press the CHECK ( ) button to
confirm your selection.
[3]
If in M-d (Month-Day) format, set the day
(flashing) with the DOWN (
) or UP (
) arrow
buttons. If in d-M (Day-Month) format, set the
month (flashing) with the DOWN (
) or UP (
)
arrow buttons. Press the CHECK ( ) button to
confirm your selection.
[4]
Set the hour (flashing) with the DOWN (
) or
UP (
) arrow buttons. Press the CHECK ( ) button
to confirm and continue on to set the minute.
Note: Dispose of used batteries according to your local environ-
mental regulations. Your meter is an electronic device. When dis-
posing of your meter follow all local environmental regulations.
Replacing the Batteries
[1]
Open Battery Door:
Make sure the meter is
deactivated. Turn the meter so you are looking
at the battery door. Press the battery door clip to
open. Remove the battery door. Be careful not to
misplace the battery door.
[2]
Remove and Install the meter battery:
To remove the used battery, pull the appropriate
tab to pop out the battery. Install the new battery
with the positive (+) sign facing up towards you.
[3]
Remove and Install the backlight battery:
To remove the used battery, pull the appropriate
tab to pop out the battery. Install the new
battery with the positive (+) sign facing
up towards you.
[4]
Close Battery Door:
Angle the
battery door back onto the meter and
swing down until it snaps gently into
place. Make sure that the battery door
is completely closed before using.
IMPORTANT:
When the meter is deactivated
and you are replacing battery #2, the time and
date information may be lost after the battery
is removed from the meter. If this happens,
1
12
12
CR2032
CR2032
CR203
CR2032
CR2032
CR2032
CR203
CR203
CR2032
CR2032
activate the meter after installing the new battery and it
will prompt you to set the time and date.