WaveSense Presto Owner's Manual - page 22
40
41
Setting Time Format,
Time, and Date
14
CHAP
TE
R
will not sound, regardless of the individual alarm setting. Also, if
your meter is set to low volume mode, then an alarm set for high
volume will default to low volume mode.
[6]
Setting Multiple Alarms: To set other alarms, press the
RIGHT or LEFT arrow buttons until the alarm you want to set
(AL1 to AL6) is displayed. Follow the previous steps in this
chapter 12, “Setting Alarms.”
[1]
Enter MENU Mode: When your meter is deactivated, press
and hold any button for 2 seconds to enter the MENU mode.
[2]
Enter SET Option: The MEM symbol will
appear. Press the RIGHT arrow button until the
SET symbol is displayed. Press the CENTER button.
[3]
Setting Meter Volume: There are three
beep volume options. The default setting is
“high.” Select the preferred volume setting with
the RIGHT or LEFT arrow buttons. Your selection
will be highlighted by the blinking of the symbol.
Press the CENTER button to confirm your
selection. Continue to set the MENU Mode Backlight option.
Note: The meter will always produce a beeping sound after you
have applied blood or control solution to a test strip. This sound
lets you know when to take your blood sample or control solution
away from the test strip. You will hear this sound if the volume is
set to ON or OFF in the SET Options.
Setting Meter Volume and
Backlight
13
CHAP
TE
R
[4]
Setting Backlight Option: You can enable or
disable the backlight. The default setting for the
backlight is enabled.
Select the preferred setting with the RIGHT or
LEFT arrow buttons. Press the CENTER button to confirm and
continue on to set the Time Format and Time.
Note: Disabling the backlight in the SET menu also disables
backlight for alarms.
[1]
Enter MENU Mode: When your meter is deactivated, press
and hold any button for 2 seconds to enter the MENU mode.
[2]
Enter SET Option: The MEM symbol will
appear. Press the RIGHT arrow button until the
SET symbol is displayed. Press the CENTER button.
[3]
Setting Time: Press CENTER repeatedly until
you see a screen with the message 12H or 24H,
you are ready to set the meter’s time.
Select a 12 or 24 hour clock format with the
RIGHT or LEFT arrow buttons.
The 12 hour clock display option is indicated
by a 12H. The 24 hour clock display option is
indicated by a 24H. Your selection will be highlighted by the
blinking of the symbol.
:
PM