WaveSense Presto Owner's Manual - page 23
42
43
Press the CENTER button to confirm your selection and move
on to the hour setting.
Set the hour (flashing) with the RIGHT or LEFT arrow buttons.
Press the CENTER button to confirm and continue on to set
the minute.
Set the minute (flashing) with the RIGHT or LEFT arrow
buttons. Press the CENTER button to confirm and continue on
to set the date.
[4]
Setting Date: Set the month (flashing) with the RIGHT or
LEFT arrow buttons. Press the CENTER button to confirm and
continue on to the day setting.
Set the day (flashing) with the RIGHT or LEFT arrow buttons.
Press the CENTER button to confirm and move on the year
setting.
Set the year (flashing) with the RIGHT or LEFT arrow buttons.
Press the CENTER button to confirm and continue on to set
the Hypo Limit.
Year:
Day:
Hour:
:
PM
Minute:
:
PM
Month:
Setting Hypoglycemic and
Hyperglycemic Warning Alarms
15
CHAP
TE
R
[1]
Enter MENU Mode: When your meter is deactivated, press
and hold any button for 2 seconds to enter the MENU mode.
[2]
Enter SET Option: The MEM symbol will appear. Press the
RIGHT arrow button until the SET symbol is displayed. Press
the CENTER button.
[3]
Setting Your Hypoglycemic Warning Alarm:
WARNING: Your healthcare professional should recommend
what your hypoglycemic limit is.
Press the CENTER button repeatedly until you see the HYPO
symbol in the top right corner of the screen. You are ready to
set the Hypoglycemic Warning Alarm. The Hypoglycemic and
Hyperglycemic Warning Alarms are set to “OFF” by default.
The Hypoglycemic Warning Alarm alerts you when your glucose
test results are below the hypoglycemic limit that you have set. The
meter is pre-set to a hypoglycemic limit of 70 mg/dL. Always consult
your healthcare professional for your recommended target ranges.
When your glucose test results are below your set hypoglycemic
limit, the date, time and result will flash on the display.
Set the Hypoglycemic Limit ON or OFF with the
RIGHT or LEFT arrow buttons. Your selection will
be highlighted by the blinking of the symbol. Press
the CENTER button to confirm your selection.
mg /dL