Wavetek 85XT Operator's Manual - page 15
Un circuit ouvert est affiché par un dépassement de calibre.
Note:
Pour des faibles valeurs de résistance, mesurez d’abord la résistance des
cordons de test (en court-circuitant les pointes), et déduisez cette valeur de la
mesure ultérieure.
DIODE AND TRANSISTOR TEST (See Fig. 4)
The diode test measures the voltage drop across a diode junction.
❶
Connect the
red test lead to the V•
Ω
Input and the black test lead to the COM Input.
❷
Set the
Function/range switch to
position.
❸
Apply probe tip of red lead to the
anode and of black lead to the cathode of the diode.
❹
The meter’s display
indicates the forward voltage drop (approximately 0.6V for silicon diode or 0.4V
for germanium diode). Meter will display overload condition for an open diode.
➎
Reverse test lead connections to the diode to perform a reverse bias test. Overload
indicates a good diode.
Notes:
Overload conditions for both reverse and forward
bias tests indicate an open diode. A low voltage reading for both bias tests
indicates a shorted diode. If the diode is shunted by a resistor of 1000 ohms or
less, it must be removed from the circuit before taking the measurement. Bipolar
transistor junctions may be tested in the same manner described above.
D • Dioden- und Transistortest (siehe Fig. 4)
Der Diodentest zeigt den Spannungsabfall über den Diodendurchgang
❶
Rotes
Meßkabel mit V-
Ω
Eingang und schwarzes mit COM Eingang verbinden.
❷
Funktionsschalter auf
stellen.
❸
Meßkabel mit Diode verbinden – rotes mit
Anode; schwarzes mit Kathode.
❹
Spannungsabfall in Durchlaßrichtung ablesen
(ung. 0.6V für eine Silikon-Diode und 0.4V für eine Germaniumdiode. Eine offene
Diode wird mit Überlast angezeigt.
➎
Verbindung umdrehen um in Sperrrichtung zu
messen. Überlast zeigt eine gute Diode an.
Anmerkung:
Überlast in beiden
Richtungen zeigt eine offene Diode an; eine niedrige Ablesung eine
kurzgeschlossene Diode. Transistorübergänge können wie Dioden getestet werden.
E • Comprobación de diodos y transistores (vea Fig. 4)
En esta prueba se mide la caída de tensión en la unión del diodo.
❶
Conecte la
punta de prueba roja a la entrada V-
Ω
y la negra a la entrada COM.
❷
Ponga el
selector en la posición
.
❸
Aplique la punta de prueba roja al ánodo del
diodo y la negra al cátodo.
❹
El visualizador indica la caída de tensión directa
(aproximadamente 0.6 V para diodos de silicio, o 0.4 V para diodos de germanio).
Una unión abierta se indica como condición de sobrecarga.
➎
Invierta la conexión
de las puntas de prueba para verificar la polarización inversa del diodo. La
condición de sobrecarga indica un diodo en buen estado.
Notas:
La condición de sobrecarga en ambos sentidos indica un diodo abierto. Un
- 13 -
85XT.Man.07.00 9/11/00 7:53 PM Page 13