Wayne-Dalton 6600 Installation Instruction And Owenrs Manual - page 6
6
A. FLAG ANGLES (AS REQUIRED):
A1. Fully Adjustable (F.A.) Flag Angles
B. JAMB BRACKETS (AS REQUIRED):
B1. Fully Adjustable (F.A.) Jamb Brackets
C. TRACK ROLLERS (AS REQUIRED):
C1. Short Stem Track Rollers
C2. Long Stem Track Rollers
D. GRADUATED END HINGES:
D1. Single Graduated End Hinges (S.E.H.), Industry Standard
D2. Double Graduated End Hinges (D.E.H.), Industry Standard
E. STACKED SECTIONS:
E1. Top Section
E2. Intermediate(s) Section
E3. Lock Section
E4. Bottom Section
F. TOP FIXTURES (AS REQUIRED):
F1. Top Fixture Assemblies
F2. Top Fixture Bases - (L-Shaped)
F3. Top Fixture Slides
F4. “L” Reinforcing Brackets (As Required)
G. STRUT(S) (AS REQUIRED):
G1. Strut (U - shaped)
H. DRAWBAR OPERATOR BRACKET (FOR TROLLEY OPERATED DOORS):
H1. Top Half Drawbar Operator Bracket / H2. Bottom Half Drawbar Operator Bracket
I. TRACKS (AS REQUIRED):
I1. Left Hand And Right Hand Horizontal Track Assembly
I2. Left Hand And Right Hand Vertical Tracks
I3. Left Hand And Right Hand Vertical Track Assembly
I4. Left Hand And Right Hand Angle Mount Vertical Track Assembly
J. TORSION SPRING ASSEMBLY (AS REQUIRED):
J1. Left Hand and Right Hand Torsion Springs (As Required)
J2. Counterbalance Lift Cables
J3. Left Hand And Right Hand End Bearing Brackets (As Required)
J4. Left Hand And Right Hand Cable Drums
J5. Center Bracket(s) (As Required)
J6. Center Bracket Bearing (As Required)
J7. Torsion Shaft / Torsion Keyed Shaft (As Required)
J8. Torsion Keyed Shafts (As Required)
J9. Keys (As Required)
J10. Center Coupler Assembly (As Required)
K. REAR BACK HANGS:
K1. Left Hand And Right Hand Rear Back Hang Assemblies
L. BOTTOM CORNER BRACKETS (AS REQUIRED):
L1. Left Hand and Right Hand Bottom Corner Brackets
M. TRACK ROLLER CARRIER’S (AS REQUIRED):
M1. Track Roller Carrier’s
N. BOTTOM WEATHER SEAL:
N1. Bottom Weather Seal (Door Width)
B1.
B1.
C1.
E4.
E1.
E2.
E3.
F1.
F3.
I2.
I1.
I1.
I2.
K1.
K1.
J3.
J5.
J3.
J2.
J1.
J4.
J2.
J1.
J7.
I4.
I4.
F2.
F1.
F2.
F3.
I3.
I3.
C1.
J3.
J3.
J10.
J9.
J8.
J8.
J5.
J6.
J6.
J4.
NOTE:
The illustrations shown on this page are
general representations of the door parts. Each
specific door models may have unique variations.
J9.
J9.
J9.
C2.
D1. D2.
C1.
H1.
H2.
G1.
N1.
L1.
L1.
L1.
M1.
M1.
L1.
F4.
F4.
A1.
A1.
BREAKDOWN OF PARTS