1. DL manuals
  2. Wayne-Dalton
  3. Garage Door Opener
  4. TORQUEMASTER 6100
  5. Quick Start Manual

Wayne-Dalton TORQUEMASTER 6100 Quick Start Manual

Other manuals for TORQUEMASTER 6100: Installation Instructions And Owner's Manual
Manual is about: Single and Double Spring

Summary of TORQUEMASTER 6100

  • Page 1

    Garage doors & openers s t a n d a r d l i f t t o r q u e m a s t e r ® p l u s 6100 mh quick start guide parts breakdown 2 pre - installation 3 important safety instructions 3 preparing the opening 3 installation 3 maintenance 10 cleaning your garage door 10 painting your garage door 10 operation ...

  • Page 2

    2 please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com a. Flag angles (as required): a1. Fully adjustable (f...

  • Page 3: Warning

    Pre - installation important safety instructions definition of key words used in this manual: warning warning indicates a potentially hazardous situation which; if not avoided, could result in severe or fatal injury. Caution: property damage or injury can result from failure to follow instructions. ...

  • Page 4: Warning

    Vertical track using (2) 1/4”-20 x 9/16” track bolts and (2) 1/4”-20 flange hex nuts. Repeat for other side. Flange nuts will be secured after flag angle spacing is completed in step, top section. Horizontal track angles tools: hammer 3 note: for larger doors, a full length horizontal track angle ma...

  • Page 5

    Side must be raised the height of the shim. Position the left hand vertical track assembly over the track rollers of the bottom section. Make sure the counterbalance lift cable is located between the track rollers and the door jamb. Drill 3/16” pilot holes into the door jamb for the lag screws. Loos...

  • Page 6: Warning

    Warning warning do not raise door until horizontal tracks are secured at rear, as outlined in step, rear back hangs, or door could fall from over- head position causing severe or fatal injury. Level the horizontal track assembly and bolt the horizontal track angle to the first encountered slot in th...

  • Page 7: Warning

    Ter ® spring tube assembly. Lift the torquemaster ® spring tube assembly and rest it on top of the flag angles. Note: cable drum assemblies are marked right and left hand. Cable drums and torquemaster ® spring tube assembly is cam shaped to fit together only one way. Starting on the right hand side,...

  • Page 8: Warning

    Seated in the first and second grooves of the cable drum. Pull on the end of the cable to remove all cable slack. Snug the set screw and then tighten an additional 1-1/2 turns. Measure approximately 6” of cable and cut off excess cable. Insert end of the cable into the hole of cable drum. Repeat for...

  • Page 9: Warning

    Using perforated angle (may not be supplied), (2) 5/16” x 1-5/8” hex head lag screws and (3) 5/16” bolts with nuts (may not be supplied), fabricate rear back hangs for the horizontal tracks. Attach the horizontal tracks to the rear back hangs with 5/16”-18 x 1 hex bolts and nuts (may not be supplied...

  • Page 10: Warning

    Maintenance cleaning your garage door important: do not use a pressure washer on your garage door! While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been exposed to dirt-laden atmos...

  • Page 11: Warning

    Warning warning never remove, adjust, or loosen the bolts, screws and/or lag screws on the counterbalance (end or center bearing brackets) system or bottom brackets of the door. These brackets are con- nected to the spring(s) and are under extreme tension. To avoid possible severe or fatal injury, h...

  • Page 12

    After installation is complete, fasten this manual near the garage door. Please do not return this product to the store thank you for your purchase. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a ...