Wbox HD2s User Manual - User Interface
C
hapter 5 >> Main Menu
27
User Interface
1
Select
User Interface using the Arrow (▲/▼) buttons on the menu and press the OK button.
2
Select a setting using the
Arrow (▲/▼) buttons and press Configuration the OK button.
Available settings are listed below:
(1)
Instant Timeshift: If you enable the instant timeshift,
the timeshift function will operate automatically.
(2)
PVR Start Margin: This setting adjusts all scheduled
recordings to start earlier. (Disabled, 1, 2, 5, or 10 minutes)
(3)
PVR End Margin: The time that is automatically added
to each recording after the program is expected to end.
(Disabled, 5, 10, 15, 20, or 30 minutes)
(4)
Autodelete Oldest Recordings: If you enable this setting, the oldest recording in each
keyword recording will be automatically removed when its quota is exceeded.
(5)
Default PVR Quota: This setting defines a default disk space quota for new keyword
recordings.(10GB, 20GB, 50GB, 100GB, 200GB, 500GB or Unlimited)
(6)
Screensaver Timeout: If you don’t take any action, the screensaver screen will be
displayed after this timeout setting. (Disabled, 5, 10, or 15 minutes)
(7)
OSD/Banner Display Time: When the OSD/Banner is shown it will be hidden after this
display time setting. (2, 5, 10, and 15 seconds)
System Settings
1
Select
System Setting using the Arrow (▲/▼) buttons on the Configuration menu and
press the
OK button.
2
Select an action using the
Arrow (▲/▼) buttons and press
the
OK button. Available actions are listed below:
(1)
Restart Device: If you select Restart device and press
the OK button, the STB will reboot itself.
(2)
Restore Factory Default: Reset back to the factory
default settings. PIN input is needed to execute this
action.
System information
1
Select
System information using the Arrow (▲/▼) buttons on the Configuration menu and
press the
OK button.
2
Select a setting using the
Arrow (▲/▼) buttons and press
the
OK button. Available settings are listed below:
(1)
IP Network: Ethernet status, DNS1 and DNS2 can be
viewed with this option.
(2)
Software: Firmware version, and Software Update
Check can be viewed with this
option.
(3)
Chip id: Chip id of the device for chipset pairing.
M_180_DNA_HD-T63CX_ENG_120322_jte.indd 27
2012-03-22 2:41:28