WDH WDH-220B User Manual - page 20
37 38
earlier according to actual operating environment.
ATTENTION:
Please turn power off and pull out power plug before replacing the filter net.
6. Fault handling
This chapter lists out possible faults when using this product. If faults could not be
resolved by using the following information, please contact TCL customer service
center or the distributor.
Status
Possible reason
Possible solution
The machine
cannot
start and
operate.
Front panel is not installed
properly.
Dismantle the front panel, and reinstall
the front panel.
Power plug is not inserted.
Pull the power plug out and insert it
again.
Power plug or electric wire
is damaged.
Contact customer service center or the
distributor.
Performance of the filter
net is exhausted without
changing.
The
machine
stops running.
Please refer to instructions and change
filter net.
The fan does
not work.
The machine is not turned
on.
Insert the power plug and restart the
machine.
Electric motor is damaged.
Contact customer service center or the
distributor.
The machine is put on
uneven surface.
Move the machine to a flat and stable
surface.
Loose or foreign particles
are inside the machine.
Contact customer service center or the
distributor.
Electric motor is loose.
Contact customer service center or the
distributor.
Did not remove plastic
packing of each filter net.
Remove plastic packing of each filter
net before use.
Wind speed
cannot be
adjusted
automatically
when auto
mode is
activated.
Night mode is automatically
started. LED light of the
machine is off. Meanwhile,
wind speed and noise level
are reduced.
Continuously press wind speed button
to choose a favorable wind speed.
Washable filter net is dirty.
Wash the washable filter net.
Filter nets are not changed.
Change a new set of filter nets.