WEATHER DIRECT WD-3312 Owner's Manual - page 12
Version 2 - 12/22/2011
Page 12 of 24
the weather data collected by the Outdoor Sensor will not be affected by the temperature of the
air leaving the attic.
We have provided a mounting plate that you can attach to the wall with the supplied screws.
Gently snap the Sensor onto the holding pegs on the mounting plate after the plate is screwed to
the wall. When the holding pegs are securely locked into the slots on the Sensor, you will hear a
“Click”.
Gateway Installation
The Gateway should be installed indoors in an easy-to-
reach location. Registration requires that you press the
gray button on the Gateway. It can be mounted
securely to the wall with the included mounting plate
and drywall anchors.
If you require a longer LAN cable to mount the Gateway
in a desired location, any standard Category 5 network
cable will work, but a crossover cable may not work.
Crossover cables designed to connect two computers
without networking hardware may not work with your
Gateway.
NOTE: Network cables usually have length limitations. The same length
limitations will apply that apply to computers on your home network.
Online Resources
These links can help to enrich your Weather Direct® experience:
•
Help –
www.weatherdirect.com/help
•
For a list of places to choose from as forecast locations -
www.weatherdirect.com/places
Time Setting on Wireless Display
The Time Zone you select on
www.weatherdirect.com
for your Wireless Display is
intended to set the time for your physical location so
the clock on your Wireless Display is accurate.
This time is independent of your selected forecast
locations. The Wireless Display will ONLY display
the time from the “Time Zone for Wireless Display
Clock” set on the web site, NOT the time at the
forecast locations. There is only one Time Zone
available per Wireless Display.
The Daylight Saving Time (DST) checkbox on your
Wireless Display settings at
www.weatherdirect.com
is selected by default
because most locations observe DST. If you are in
a location that does not observe DST, please make
sure to uncheck this box.