Weather-Rite UHA100 Installation, Operation & Service Manual - Warning

UHA L

OW 

P

ROFILE 

U

NIT 

H

EATER 

I

NSTALLATION 

O

PERATION AND 

S

ERVICE 

M

ANUAL

10 of 51

SECTION 6: HEATER INSTALLATION

6.1 General 

Heaters are designed for installation above 6' 

(1.8 m). These heaters must be installed within the 

heated space. Duct delivery systems are not 

permitted with axial fan units. When handling or 

supporting the heater from below, ensure that the 

weight is taken at the support points.

The gas or electrical supply lines must not be used 

to support the heater.

Do not locate the gas or electrical supply lines 

directly over the path of the flue products from the 

heater. 

The heater must be installed in a location that is 

readily accessible for servicing.

The heater must be installed in accordance with 

clearances to combustibles as indicated on the wall 

tag and this manual.

6.2 Shelf Mounting and Suspension

For typical suspension, See Page 11, Figure 5.

For typical shelf mounting on existing shelf, See 

Page 11, Figure 6.

6.3 Wall Mounting

For typical suspension, See Page 12, Figure 7. Wall 

mounted heaters blowing parallel to the wall can 

only be installed with the service door away from the 

wall.

The wall mounting brackets must be attached to a 

suitable wall using all mounting holes. Screw sizes 

less than 3/8" may not be used. In order for the wall 

mounting brackets to adequately carry the weight of 

the heater, it must be installed according to best 

building practices.

WARNING

Crush Hazard

Use 3/8" threaded rod 

minimum.

Failure to follow these 

instructions can result in 

death, injury or property 

damage.