Webasto AIR TOP 2000 ST EVO Installation And Operation Instructions Manual - page 5
SmarTemp Control
Installation - Operating Instructions
5
Time & Date
Set time and date using the rotary knob and selection button.
12 (AM / PM) or 24 hour available.
12 hour
Offset
Depending on the installation location, the temperature
reading may vary slightly. The Offset feature allows a
temperature adjustment of +/- 9°F (+/- 5°C). Adjust this as
necessary to obtain the most accurate ambient temperature
reading.
0°
Default
Default allows the user to perform a factory reset of the
control settings.
NOTE: Heater information will NOT be affected.
N/A
SW Version
This displays the firmware version of the Webasto SmarTemp
Control.
Installed
Version
Back
Select this to return to the previous screen.
N/A
Technical Information:
– Rated Voltage: 12 / 24V
– Operating Voltage Range: 12V: 11 – 16V | 24V: 21 - 32V
– Low Voltage Disconnect Range: 12V: 11 – 12.5V | 24V: 21 – 25.5V
– Operating Temperature: - 40° ... +185 °F (- 40° ... +85 °C)
– Set Temperature Range: 41° - 95° F (5° - 35° C)
– Installation Dimensions: (L x H x D) 2.7” x 2.2” x .60” (69.4mm x 55.5mm x 15.2mm)
Drilling Dimensions
Use the dimensions / template located in the back of this manual as a guide when installing and
mounting the Webasto SmarTemp Control.
NOTE: The Webasto SmarTemp Control has an integrated ambient temperature sensor. To ensure
this sensor properly measures the surrounding air, the control must be mounted vertical only.