Webasto Air Top 2000 ST Operating, And Servicing Instructions - page 3
Switch on
General
Switch off
Operation
Error code
Set time/date
View time
Program
Start time
View/Delete
selected
times
Program
operating
time
Set remaining
time
Remote control
Vehicles with
ADR
equipment
Manual: Press the
(permanent heating mode)
Automatic: By programming the start time
The combination timer allows the heater start time to be selected for
a period of up to seven days. Three cut-in times can be programmed,
although only one of them may be activated.
The combination timer has a temperature setpoint generator.
When the ignition is switched on the timer shows the current time
and the day. If the heater is operating the display and the buttons
are lit.
When the timer is connected to the power supply all the symbols in
the display will flash. The time and day must be set. The display
remains blank in ADR vehicles.
The operation of the timer is designed such that all the flashing
symbols can be adjusted using the
and
buttons. If no button is
pressed for five seconds the displayed time is saved. If the
and
are pressed for longer than two seconds, they will switch to high
speed adjustment.
If the ignition is switched off whilst the heater is in permanent heating
mode, a remaining operating time of 15 minutes will appear on the
display and the heater will continue to operate.
On heaters that output an error code (Air Top 2000 ST),
a number, the error code, may appear in the display. In this case you
should visit a Webasto service outlet.
Manual: Press the
button again
Automatic: By programming the operating period
When the heater is operating: By setting the remaining time
Press the
button for more than two seconds the time will flash
set the time using the
and
buttons the day will flash set the
day.
-
-
-
-
Ignition off: Press
button.
Press
button
program number will flash set the start time using
the
and
buttons the day will flash set the day.
If you press the
button several times you can set program
numbers 2 and 3 or go to time mode.
-
-
-
-
Press the
button several times until the required program number
is displayed.
To delete the selected time press the
button until the time is
displayed with no program numbers.
-
The heater must be switched off. Press the
button for three
seconds the operating duration will flash set the required operating
duration using the
and
buttons (10 to 120 minutes).
-
-
Set the required remaining time (1 to 120 minutes) using the
and
buttons. The remaining time is the time that the heater will
continue to operate. It can only be changed whilst the heater is
operating and the ignition is off.
Possible using an external optional immediate heat button.
It is not possible to set a time on ADR vehicles. The remaining time
will be shown on the display whilst the heater is operating. The time
can be adjusted.
Combination timer
2
MO
Combination
timer
Indicator
Temperature
selector
Forward
Immediate
heat
Return
Program selector
Time
Program number
Day