Webasto Dual Top Evo 6 Operating Instructions Manual - page 10
Operating Instructions
Dual Top Evo 6
10
4.2.2
Winter mode (heating without hot water production)
1
Move interior temperature selector (B) on the control panel to desired thermostat
setting for interior temperature.
2
Move mode selector knob (A) to winter mode, heating without hot water
production (3) on control panel.
The indicator (C) on the control panel lights green when the equipment is switched on.
The red indicator on the mode selector knob (A) as well as on the interior temperature
selector (B) both illuminate.
When the selected interior temperature is approached, the heater starts to modulate.
The power is adjusted to a level necessary to maintain a constant temperature.
In case the interior temperature exceeds the selected temperature, due to
environmental influences, the combustion inside the heater stops.
NOTE
Please note that, in case the boiler has been filled, the water is automatically heated as
well. The water temperature may reach up to 80 °C depending on the power and the
duration of the heating.
4.2.3
Winter mode (heating with hot water production)
1
Make sure that the boiler is filled with water.
2
Move interior temperature selector (B) on the control panel to desired thermostat
setting for room temperature.
3
Move mode selector knob (A) to winter mode, heating with hot water
production (4) on control panel.
The indicator (C) on the control panel lights green when the equipment is switched on.
The red indicator on the mode selector knob (A) as well as on the interior temperature
selector (B) both illuminate.
The heater gradually reduces the power until the selected interior temperature is
reached. If the interior temperature has been reached, but the water temperature is still
too low, the blown air circulation fan switches off and the water continues to be heated
to a temperature of 70 °C.
The water temperature may reach up to 80 °C depending on the heating power that is
required to achieve the interior temperature.