Webasto Hollandia 900 Operating Instructions Manual - page 3
USER MANUAL HOLLANDIA 900
En
glish
4
Dear Madam, Sir,
English
Webasto Product International would like to thank you for purchasing
a Hollandia 900 Series Sunroof. Your sunroof is a quality product de-
signed by Webasto Product International, the Netherlands. Below you
will find all you need to know about the Hollandia 900 Twin Panel tilting
and sliding sunroof. In order to obtain the maximum enjoyment from
the sunroof, please read these instructions carefully. Wishing you hap-
py motoring.
SOFT-TOUCH SWITCH
Make sure that the ignition of your vehicle is ON.
By quickly pressing the switch (approx. 0.1 seconds) the sunroof
will open
or close
immediately (depending on the position
of the panels). Movement of the panels can be stopped by quickly
pressing the switch again.
By briefly pushing the single
or double
vent button, the
glass panels will move immediately into the corresponding posi-
tions.
CLOSING OF THE SUNROOF
By briefly pushing the close button
, regardless the panels po-
sition, the panels will close immediately.
AUTO-CLOSE
When turning off your vehicle’s ignition, the sunroof will make a
beep sound to remind you that the auto-close will be activated.
After three seconds the sunroof will close automatically which will
be indicated by one short beep.
Should you require the sunroof to stop, just briefly press the switch
or
. You can also prevent the panels from closing by press-
ing the switch
or
during the three seconds interval.
When you switch the ignition on, the sunroof opens and closes in
the normal way.
JAMMING PROTECTION
The jamming protection becomes active when the sunroof is
closed either by soft-touch control or in auto-close mode. Should
a panel encounter an obstacle while closing, it immediately opens
again:
•
Ignition ON, Soft-Touch control:
The sunroof will try to close (max. 8 times) until the obstacle
has been removed.
•
Ignition OFF, Auto-Close:
The sunroof will remain open.
COMFORT POSITION
With this feature you are able to program a preset position of the
panels of the sunroof. The panels will move to the preset position
when briefly operating the comfort button
.
PROGRAMMING THE COMFORT POSITION:
1.
Place the panels in the preset position using button
or
.
2.
Push the comfort button
and hold the button for about 6
seconds until you hear a beep.
On opening the sunroof with the comfort button
(press approx.
0.1 sec.) the panels will stop in the preset position.