Webasto Thermo 90 ST Installation Instructions Manual - page 6
Thermo 90 S / Thermo 90 ST
Statutory regulations governing installation
35
1
Statutory regulations governing installation
1.1.
Statutory regulations governing installation
The Thermo 90 S / Thermo 90 ST heater has been type-tested and
approved in accordance with EC Directives 72/245/EEC (EMC), 2001/
56/EC (heater) and ECE R122 with the following EC permit numbers:
e1*2001/56*2004/78*0005*--
e1*72/245*95/54*1173*--
e1*2001/56*2004/78*0019*--
E1 R122 00 0217
Primarily the regulations of Annex VII of the Directive 2001/56/EG and
Part 2 or Annex 7 of the directive ECE R122 must be observed for the
installation.
NOTE:
The provisions of these Directives are binding within the territory
governed by EU Directive 70/156/EEC and should similarly be
observed in countries without specific regulations.
IMPORTANT
Failure to follow the installation instructions and the notes contained
therein will lead to all liability being refused by Webasto. The same
applies if repairs are carried out incorrectly or with the use of parts other
than genuine spare parts. This will result in the invalidation of the type
approval for the heater and therefore of its
homologation / EC type
licence
.
(Extract from Directive 2001/56/EC Annex VII)
1.7.1.
A clearly visible tell-tale in the operator's field of view shall inform
when the combustion heater is switched on or off.
2. Vehicle installation requirements
2.1. Scope
2.1.1.
Subject to paragraph 2.1.2, combustion heaters shall be installed
according to the requirements of this Annex.
2.1.2.
Vehicles of category O (
trailers
) having liquid fuel heaters are
deemed to comply with the requirements of this Annex.
2.2. Positioning of heater
2.2.1.
Body sections and any other components in the vicinity of the
heater must be protected from excessive heat and the possibility of fuel
or oil contamination.
2.2.2.
The combustion heater shall not constitute a risk of fire, even in
the case of overheating. This requirement shall be deemed to be fulfilled
if the installation ensures an adequate distance to all parts and suitable
ventilation, by the use of fire resistant materials or by the use of heat
shields.
2.2.3.
In the case of M2 and M3 vehicles, the heater must not be
positioned in the passenger compartment. However, an installation in an
effectively sealed envelope which also complies with the conditions in
paragraph 2.2.2 may be used.
2.2.4.
The label referred to in paragraph 1.4 (
model plate
), or a duplicate
(
duplicate model plate
), must be positioned so that it can be easily read
when the heater is installed in the vehicle.
Visit www.butlertechnik.com for more technical information & downloads.
www.butlertechnik.com