Webee SWITCHEE Getting Started - page 5
Webee Switchee
GETTING STARTED WITH SWITCHEE
5
Getting started
Page 0
In order to connect the Switchee to your existing power outlet follow these steps:
1- Make sure the electricity at home is off, in order to safety handle the device. As you will be
connecting the wires from your electrical current to the Swicthee is imperative that the
electricity is disabled.
2- Identify the Load 1 and Load 2 (see Diagram 2 bellow). Each Load works separately as
two different power outputs.
Ÿ
a. Connect the 2 wires from your outlet (could be from any electrical system such as
lamps, lights, etc) to the Load1-A and Load1-B connectors on the Switchee. When
connecting make sure to do it carefully as it could represent an electrical hazard since
these wires will allow AC current to flow through them.
Ÿ
b. To use the Load 2 to connect another electrical system, repeat the process by
connecting the two wires from the second electrical system to Load2-A and Load2-B
connectors on the Switchee. Once again, do it carefully to avoid electrical hazards.
Ÿ
3- Last, connect the L connector on your Switchee to the phase Live wire of your electrical
wiring and N connector of the Switchee to the Neutral wire of your electrical wiring (see
Diagram 2 bellow)
To a power outlet
Diagram Mounting Switchee to a power outlet
2:
© 2014 Webee LLC, All rights reserved. The Webee logo, Boss and Bees are trademarks or registered trademarks of Webee LLC