Webee SWITCHEE Getting Started - page 6
Webee Switchee
GETTING STARTED WITH SWITCHEE
6
CONNECTING TO SMARTEE
Getting started
© 2014 Webee LLC, All rights reserved. The Webee logo, Boss and Bees are trademarks or registered trademarks of Webee LLC
1
2
Page 0
To join the Switchee to the Smartee, click on the “Add Device” function of your App and
the Smartee will automatically connect your Switchee to the network. For more detailed
instructions check our Smartee User Manual.
If the Switchee does not automatically join the network, press and hold the Config
button. The Switchee will continuously blink erratically as it attempts to join the hub.
Upon a successful joining of the Switchee to the ZigBee network of your Smartee, the
status LED will stop blinking.
If the after following these steps the Switchee will not join the Smartee Zigbee network,
do as follows:
• Make sure the network on your Smartee is open for joining. Keep in mind that once you
clicked on Add Devices, the network will be open for 60 seconds.
•Check if the Switchee hasn’t join another network (the light will be static), see the next
step to learn how to remove it from a network in order to add it to a new one.
Once the Switchee is added to your Smartee, you will be able to start controlling it
trough your Webee App.
If it becomes necessary to remove the Switchee from a Zigbee network then you must
factory default the Switchee. To factory default the Switchee:
A. Press and hold the Switchee's CONFIG button for 5-8 seconds.
B.When the Led blinks twice release the button, LED will start blinking erratically.
C. The Switchee will now be reset to factory defaults and begin scanning for a ZigBee
network to join.
Adding to Zigbee Network
Removing from Zigbee Network