Weber BABY Q 100 Owner's Manual - page 12
12
3
1
3
2
2
CHECK FOR GAS LEAKS
m DANGER
Do not use an open flame to check for gas leaks. Be sure
there are no sparks or open flames in the area while you
check for leaks. Sparks or flames will result in a fire or
explosion, which can cause serious bodily injury or death as
well as damage to property.
You will need: LP cylinder, a soap-and-water solution and a rag or brush to apply it.
A) Mix the soap and water.
B) Turn on the cylinder valve using one of the appropriate options based on your
cylinder and regulator type.
a) Turn cylinder valve anti-clockwise
(1) (2) (3).
b) Move regulator lever to the up/ON position
(4).
c) Move regulator lever to the ON position
(5).
C) Check for leaks by wetting the fitting with the soap-and-water solution and watching
for bubbles. If bubbles form, or if a bubble grows, there is a leak.
GAS INSTRUCTIONS - LIQUID PROPANE CYLINDER
1
2
3
4
5
2
3
Check:
D) Valve-to-regulator connections
(1).
m WARNING: If there is a leak at connection (1), retighten the
fitting with a spanner and recheck for leaks with soap-and-
water solution. If a leak persists after re-tightening the fitting,
turn off the gas. DO NOT OPERATE THE GRILL. Contact
the Customer Service Representative in your area using the
contact information on our web site. Log onto www.weber.
com
®
.
E) Regulator-to-cylinder connection
(2).
m WARNING: If there is a leak at connection (2), remove
LP cylinder. Do not operate barbecue. Use a different LP
cylinder and recheck for leaks with soap-and-water solution.
If a leak persists after changing the LP cylinder, turn OFF
the gas. DO NOT OPERATE THE BARBECUE. Contact the
Customer Service Representative in your area using the
contact information on our web site.
Log onto www.weber.com
®
.
F) Hose-to-regulator connection
(3).
m WARNING: If there is a leak at connection (3) turn OFF
the gas. DO NOT OPERATE THE BARBECUE.
Contact the
Customer Service Representative in your area using the
contact information on our web site.
Log onto www.weber.com
®
.
When leak checks are complete, turn gas supply OFF at the source and rinse
connections with water.
Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
◆