Weber PLATINUM 2200 NG User Manual - Install Work Surface

9

Route the side burner hose around the tank panel so it

will not interfere with the scale indicator rod.

The side burner hose is connected in the following

manner:

Slide back the collar of the quick disconnect on the

manifold. Push the male fitting of the side burner hose

into the quick disconnect, and maintain pressure. Slide

the collar closed. Figure 12. Figure 13 shows the quick

disconnect engaged.

Check that the side burner is properly assembled.

Manifold side view

Manifold side view

Figure 12

Figure 13

Male fitting

Quick disconnect

engaged

Side burner

hose

(c)

(a)

(b)

Figure 15

INSTALL WORK SURFACE

AND SIDE BURNER

FOR THE PLATINUM SERIES II 3200

(CONTINUED)

View from right

underside

To NG

supply

To side burner

WARNING:  Set the burner ring onto the burner head

with the slots facing up. Rotate the burner ring until

the four lugs on the burner ring are seated in the four

slots on the burner head. Figure 15 (b).

Note:  The burner head has a hole in it that fits over the

igniter electrode.

After this assembly, proceed to step “Install Bottom

Rack” on page 12.

Figure 14

Windshield

Burner

cap

Burner

ring

Burner

head

Burner

orifice

Burner

base

Grate

Slots

Lugs

Igniter

electrode