Wechillit Burco User Manual - page 2
Important safety instructions
The use of any electrical appliance requires following common sense safety rules.
Primarily there is danger of personal injury and secondly danger of damage to the
appliance and property. These are indicated in the instructions text by the following
two conventions:
WARNING: Danger of personal injury.
IMPORTANT: Damage to the appliance.
In addition we offer the following essential safety advice.
General information
Scale build up can damage any appliance which boiling water passes through.
Failure to descale your Burco autofill water boiler will invalidate your guarantee.
Before general use it is recommended that the unit is boiled and emptied through
the tap twice discarding the water each time. For best taste and to protect your water
boiler from limescale Burco suggest you filter the water supply.
Location
•
Do not use your autofill water boiler outside.
•
All sides must be at least 100mm from any walls.
•
On a flat level surface.
Ambient Temperature
This appliance is designed to operate in an ambient temperature between 10ºC
and 40ºC.
Mains lead
•
The mains lead should reach from the wall socket the autofill water boiler without
straining the connections.
•
Do not let the cord hang over the edge of the table or the counter and keep it
away from any hot surfaces.
•
Do not let the lead run across an open space e.g. between a low socket and table.
•
Do not place the autofill water boiler where the mains lead could fall into a sink.
Your safety
WARNING: Extreme caution must be used when moving the autofill
water boiler as it is very heavy.
•
Do not continue to use the water boiler if the warning lights are flashing, consult
advance diagnostics service light warning codes.
•
Do not use boiler if it has been damaged in any way.
•
Do not place the appliance on or near hot surfaces.
•
Do not use accessories or attachments which Burco have not recommended as
they can cause hazards.
•
Always switch off, empty and disconnect the autofill water boiler before moving
the unit.
WARNING: The only parts you should touch behind the front panel
are the two red isolation valves and the reset button.
WARNING: To avoid being scalded when the water boiler is in
operation or has just been switched off keep hands away from any steam.
Be particularly careful not to touch any hot surfaces especially when
running the descale programme or when the front/ top panel is removed.
Safety considerations
Important: do not use a water jet to clean this appliance.
Important: do not use this appliance in an area a water jet can be used.
Important: this applaince is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety. Children should be supervised
to ensure that they do not play witht the appliance.
Important: This appliance is only to be installed in locations where its use and
maintenance is restricted to trained personnel.
•
To protect against fire, electric shock and personal injury do not immerse cord,
plug or water boiler in water or any other liquid.
•
Do not tamper with the connector in any way.
•
If the mains lead is damaged, it should be discarded and replaced.
•
Turn off and unplug when not in use.
•
Maintenance other than cleaning and descaling should be carried out by the
manufacturer while this product is within guarantee. (Contact our service helpline
on 0871 222 2620).
•
Warranty is only valid in the UK.
IMPORTANT: This appliance must only be used for heating water.
Electrical requirements
Check that the voltage on the rating plate of your appliance corresponds with
your electricity supply which must be A.C. (Alternating Current).
For appliances fitted with a plug
If the socket outlets are not suitable for the plug supplied with this appliance, the
plug should be removed and the appropriate one fitted.
WARNING: The plug removed from the mains lead, if severed, must be
destroyed as a plug with bared flexible cord is hazardous if engaged into a
live socket outlet.
WARNING: This appliance must be earthed.
Should the fuse in the 13A plug require changing, a 13A BS 1362 fuse
must be fitted.
IMPORTANT: Installation must be carried out by an appropriately qualified
service engineer. Any damage caused by installation by an un-qualified individual will
invalidate your warranty.
Fitting a plug
The mains lead of this urn will already be fitted with a BS1363 13A plug. In the
event of replacing a fuse, a 13 amp fuse approved by ASTA or BSI must be used. If
the plug is not suitable for your socket then the plug must be cut off and disposed of
safely. An appropriate plug should be fitted as follows:
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Green-and-Yellow - Earth
Blue - Neutral
Brown - Live
The wire, which is coloured green and yellow, must be connected to the terminal
in the plug which is marked with the letter E or the earth symbol or coloured green or
green and yellow. The wire, which is coloured blue, must be connected to the terminal
which is marked with the letter N or coloured black or blue. The wire, which is coloured
brown, must be connected to the terminal which is marked with the letter L or
coloured red or brown. Make sure that the connections are tight and that there are no
loose strands of wire and no insulation trapped under the terminals. Tighten the
2
3