Wegener Unity 4600 Quick Start Manual

Summary of Unity 4600

  • Page 1

    Www.Wegener.Com 800032-02 rev. G 1 general information if equipped with a receiver card, the unity 4600 receives an l-band rf carrier from an external lnb, demodulates the carrier, and then extracts the mpeg transport stream. If equipped with an asi transport card, it decodes the asi line code and e...

  • Page 2

    Q uick s tart g uide 2 800032-02 rev. G www.Wegener.Com warnings to avoid damage to this and other equipment, or personal injury, the following items should be strictly observed. Elevated operating ambient when equipment is installed in a closed or multi-unit rack assembly, the operating ambient of ...

  • Page 3

    Q uick s tart g uide www.Wegener.Com 800032-02 rev. G 3 system setup figure 1 illustrates a typical system setup for the unity 4600 . Figure 1: unity 4600 system connections rear panel connections figure 2 and 3 illustrates the rear panel views for the unity 4600 connections. Dtmf is not available f...

  • Page 4

    Q uick s tart g uide 4 800032-02 rev. G www.Wegener.Com ethernet rj45 jack 1 txdo + 2 txdo - 3 rxdi + 4 shorted together, then terminated into an ac ground. 5 6 rxdi - 7 shorted together, then terminated into an ac ground. Serial control rs232, 9 pin d female jacks 1 dcd (internally pulled to +5v) 2...

  • Page 5

    Q uick s tart g uide www.Wegener.Com 800032-02 rev. G 5 front panel controls figure 4 shows the unity 4600 's front panel controls and indicators. There are three major parts of the front panel: the liquid-crystal display (lcd), the six push buttons, and the eight led indicators figure 4: unity 4600...

  • Page 6

    Q uick s tart g uide 6 800032-02 rev. G www.Wegener.Com led indicators eight light-emitting diodes (leds) provide status information about your unity 4600 and its processes as listed in table 2 . Table 2: unity 4600 led indicators indicator color and state description carrier green constant unit has...

  • Page 7

    Q uick s tart g uide www.Wegener.Com 800032-02 rev. G 7 warranty the following warranty applies to all wegener communications products: technical support in the event that the unit fails to perform as described, contact wegener communications customer service at: phone: (770) 814-4057 fax: (678) 624...