Wegener Unity 4600 Quick Start Manual - page 5
Q
UICK
S
TART
G
UIDE
www.wegener.com
800032-02 Rev. G
5
Front Panel Controls
Figure 4
shows the
Unity 4600
's front panel controls and indicators. There are three major parts of the
front panel: the liquid-crystal display (LCD), the six push buttons, and the eight LED indicators
Figure 4:
Unity 4600 front panel
User Interface
In operation, the
Unity 4600
Home screen appears on the LCD as shown in
Figure 5
(if using an L-band
receiver card with 4-way RF switching input - consult the online User's Manual if using an ASI input
option):
Figure 5:
Unity 4600 Home Screen
Where pp...pp is either, in order of priority (and as available): (1) the first eight characters of the user-
supplied Channel Label; or (2) the first eight characters of the Program's Service Descriptor; or (3)
Progr xx (for Program # 'xx'), or PID xxxx (for video PID 'xxxx', where 'xxxx' is in hexadecimal notation).
fffff.ff is the downlink frequency in MHz. y is the selected RF feed port number and the MM…MM field is
a marquee. The MM…MM marquee alternates between messages indicating RF signal level (0 to 100
where 100 is max power and 0 is min), Eb/No (if locked on a carrier), or others indicating unit state or
the presence of faults. Note that the flashing arrow at the lower right of the display is a prompt indicating
that the user may find other menu screens by pressing the right or left arrow buttons on the front panel.
LNB PWR **
2-pin male header (mates to
removable terminal-strip)
1
LNB DC Output positive leg
2
LNB DC Output return leg
RF IN -1 through 4
Type F coax jacks
4-way RF Switch Inputs
Front-panel monitor
option AUDIO ***
¼" stereo phone jack
Stereo audio headphone monitor, selectable between
audio ports 1 or 2
Front-panel monitor
option VIDEO
BNC Jack
Composite Video monitor
* DTMF is not available for units manufactured after 10/22/2007.
** When LNB DC is supplied on RF center pins, this header is not included. When four RF inputs are supplied
without this header, LNB DC is supplied on the center pin of Port 4. Note that COMPEL network can lock LNB
DC to OFF.
*** After plugging in headphones, the unit immediately displays a screen prompting the user to select the Audio
Port to be monitored.
Connector Designation
Type
Pin
Signal Description
LCD
push buttons
LED indicators