Wegmatt dAISy Owner's Manual - page 3
For your safety, reboot your PC after completion of the installation. This will re-enable driver signature
verification.
3.3 Windows 10
Good news! With Windows 10 no driver is required and a new COM port will automatically show up in
the DataPort drop-down of OpenCPN. See the chapter about configuring OpenCPN below for more
information.
3.4 Mac OS X
No driver is required for Mac OS X. dAISy will show be recognized a USB modem.
You can determine the ID of dAISy with the following steps:
1. Plug dAISy into a USB port
2. Launch Terminal.app
3. Type ls /dev/*usb*
4. The system will return a list of USB devices, with names like “/dev/cu.usbmodemXYZ” where XYZ
is a number.
5. Copy “/dev/cu.usbmodemXYZ” to the clipboard, where XYZ is substituted with specifics from
your setup.
6. In OpenCPN.app create a new serial connection on DataPort using the copied string. See the
chapter about configuring OpenCPN below for more information.
3.5 Linux
No driver is required for Linux. When plugged into the computer, dAISy will show up as a USB CDC
device on /dev/ttyACM0.
Detailed instructions for Linux can be found here:
https://mvcesc.wordpress.com/2015/04/28/opencpn-
on-the-raspberry-pi-2-with-ais/
Also See the chapter about configuring OpenCPN below for more information.