Wegmatt dAISy Owner's Manual - page 8
dAISy but don’t have AIS reception at your current location. You can exit test mode by pressing ESC or
power-cycling dAISy.
C: Configure receiving channel. dAISy has only one radio. To receive on both AIS channels, it
continuously switches between the two radio frequencies until a signal is detected. This option controls
whether dAISy hops between the channels, only listens to channel A, or only listens to channel B. In
some situations, only listening to one channel can increase the number of messages received. The
recommended setting is hopping between A and B.
R: Turn RSSI Detect on or off. When RSSI detect is on, dAISy will ignore signals that are too weak for
reliable communication. This may increase the number of local messages received, but it will also reduce
the maximum range. The recommended setting is OFF.
L: Turn Low Power Mode on or off: In low power mode, the CPU of dAISy will be powered down when
idle. This will reduce power consumption by about 10-15%. As this is insignificant in typical applications,
the recommended setting is OFF.
#: Save current settings (serial, C, L, R and D) as startup defaults. This is particularly useful when you
want to persist the settings for the auxiliary serial output.
B: Enter boot loader mode for firmware updates. dAISy only exits this mode through power-cycling or
after completing firmware upgrade. Firmware updates and instructions are available at